Logo

Search:

Type: Posts; User: racerone

Page 1 of 4 1 2 3 4

Search: Search took 0.13 seconds.

  1. Re: What do you use to push gear oil into the lower unit.

    Most shops will have a wee pump for that.----About $10
  2. Re: Using a 1989 Evinrude 90HP regulator/rectifier on a 1987 Evinrude 90HP

    The ones that mount on top of the block ( with gasket ) are actually water cooled.
  3. Replies
    28
    Views
    105

    Re: Low RPM? On 1991 30hp evenrude

    Or one cylinder at peak output and one that is at 1/2 output.---Check fuel pump impeller ?----Changed water pump impeller recently ?--Your boat ( load ) might not allow your engine to reach peak...
  4. Replies
    28
    Views
    105

    Re: Low RPM? On 1991 30hp evenrude

    Some will argue----Yes they sound really sweet running on one cylinder !!-----Read all the books and online you want.-----But some simple trouble shooting on your part will find the issue.----Perhaps...
  5. Replies
    9
    Views
    224

    Re: 95 force 120 head torque #2

    You need to take the block off the exhaust housing.----Do not try to do it any other way !!
  6. Replies
    28
    Views
    105

    Re: Low RPM? On 1991 30hp evenrude

    You can not test a motor for " power " when it neutral or no load.----It will rev up running on one of 2 cylinders.----But good trouble shooting will find where the issue is.
  7. Replies
    2
    Views
    23

    Re: Shifting Into Forward Gear

    Did you line up the notches on the upper and lower shift rods with the hole when you installed the 2 bolts in the brass connecter.---Yes or no ?----Did you verify shift adjustment up at the shift...
  8. Re: Best Time, Place, Way to Buy a New Outboard

    A dealer would check the motor for you.-----Start it and test it.------Answer any questions you might have.-----Show you how to start / operate this fine machinery.----Worth money to have that...
  9. Re: Using a 1989 Evinrude 90HP regulator/rectifier on a 1987 Evinrude 90HP

    The ignition system to make spark does not use 12 volts from the battery.-----The regulator / rectifier is part of the battery charging system.----If that does not work the battery will eventually go...
  10. Re: Name plate missing what year and model do i have?

    Post pictures if paint / graphics are original.
  11. Re: 1983 Evinrude 235....wires from power pack to coils order?

    Yes blue for top , sky is blue.------Green for bottom , grass is green.-------But that may not apply to the 1983 models as per wiring diagram.----1985 models appear to show the orange wires with blue...
  12. Replies
    6
    Views
    48

    Re: low compression & oil seeping

    Broken piston rings are a common failure.----Every one of these motors will suffer from that eventually !!
  13. Replies
    5
    Views
    52

    Re: Flywheel magnets

    What is your motor doing / not doing ????----What other trouble shooting have you done.----Sorry--I can not see , feel or hear your motor !
  14. Replies
    5
    Views
    52

    Re: Flywheel magnets

    They are well made these days.---Rarely a problem.-----What motor ??-----What is your motor doing / not doing?----What trouble shooting have you done.----What trouble shooting skills / tools do you...
  15. Re: Johnson outboard 6hp 1977, piston rings.

    If in Canada----evinrudeparts.ca----Might be able to help you.
  16. Re: Evinrude 70HP 1984 3Cyl 2stroke Rev RPM problems

    Does spark jump a gap of 1 cm or more on all 3 leads , yes or no ?----When was water pump impeller changed last ?----Have you tested the overheat heat warning horn ?----Replaced fuel pump diaphragm...
  17. Replies
    28
    Views
    105

    Re: Low RPM? On 1991 30hp evenrude

    Did it run OK and to 5500 RPM on this boat last year ???
  18. Replies
    6
    Views
    1,255

    Re: low compression

    What motor do you have ????----model # or serial number might help !
  19. Re: Sooo... I screwed up... Need advice on bolt extraction and dealing with seized bolts

    The motor ran on a hose.-----It did the " bark and roar " thing.----Since it ran there can not be much wrong with it !!-----As I get older I am observing that folks are really good at what they do...
  20. Replies
    7
    Views
    116

    Re: 1985 mercury 50 hp lync sinc

    Checked exhaust tuner for blockage ?
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4