Logo

Replace impeller in 40hp yamaha

Tinson

New member
Hi,I would like to replace the impeller in a CV40 Yamaha,have read the manuel and see the proceedure however I cannot see how the water pump connects to the pipe/canel to deliver the water to the engine. Is this just a push on connection or is there something there that needs to be disconnected.The proceedure,undo five retaining bolts,the gear control and remove the lower leg seems straght forward,is there something I am missing,thanks.
 
It just pushes in - there is a guide tube and rubber seal that hold it in place and "seal" it from leaking.

When you remove the lower unit the water tube will pull out of the guide on the cover - nothing to disconnect at that point...
 
Back
Top