Any ideas as to what might cause these two issue - blown fuse and fried red wire to rectifier (at least I think it is the rectifier in pic)..do I just have a bad rectifier or would the burned up red wire to rectifier and blown fuse be an indication of another problem? Motor was in shop at...
Was running fine all summer till today. First sign of trouble was Motor started surging... was cruising at 3/4 throttle, when motor started slowing down, then speeding back up, like fuel flow being interupted. It finally stalled out. Fuel bulb was soft (but not flat) I pumped fuel bulb till...
63 electric shift, starts fine, but when throttle advanced, won't get beyond a fast walk. Prop doesn't seem to be slipping, seems to be firing on both cylinders, and fuel bowl seems to be getting fuel from tank. Idles fine. Condition started during a brief outing where we were at 3/4...
Decided best i start a new thread with appropriate title...this is continuation of other thread just posted by Vandenburgh, hopefully the right call.
Update: I finally got the boat on the water today at the lake cottage so I could move beyond test barrel. Happy that engine started and idled...
I was thinking about repairing my leaky vintage 6gal original omc fuel tank for use with my 63 Johnson (I had been using motor with new plastic 6gal tank, but would like a 2nd tank for longer trips). Tank seems to leak near connection assembly at tank when it builds pressure in tank(pressure in...
Engine starts fine, and throttles up fine, but when pulling back quickly on throttle from running at 3500 rpms or so, engine stalls out. If I pull it back slowly instead, it seems to be ok. Any suggestions as to what may be the problem causing it to stall out on rapid deceleration?
I am...
I wanted to troubleshoot my charging system...I have 'freewheeled' the generator and it seems ok as it runs as an electric motor. I think my regulator is fried, but not sure. My manual has some troubleshooting tests, but they require engine running at 3/4 throttle....
As it is still too cold...
Thanks - what do you think about the condition of the two low speed needles in the picture below? The one on the right is from the working motor, the one one the left is the parts motor. Which one appears to be in better condition (if picture large enough to tell)?
what is odd is that...
Ok, I am ready to hit the upper gearcase and wanted to confirm a couple of things if possible before I leave the lower gearcase...the pinion gear should just be loose at the top of the lower gearcase, as in picture, where it will be inserted into to upper gearcase when reassembled? Correct? I...
Thanks. Can you recommend which of the forward gears in the picture I should choose to reinstall? The two gears on the top (one on the top left is forward) were from my 'running engine' although I was having problems with the 'running' engine in forward (forward wouldnt work when i got the...
I am attempting to reseal leaky lower unit on my old 40HP johnson electric shift (novice first timer). leak appears to be between upper and lower gearcase and likely other locations as gearcase oil becomes milky after about 30min on the water and then motor no longer shifts into forward (I am...