Logo
FULL SITE MENU

Recent content by twinsprop

  1. T

    25 etec injector prob ( cleaning)

    Can you clean a injector on a 25 hp etec
  2. T

    2000 Yamaha VMax 150 0x66 fuel injection

    this motor is over oiling and plugs are black. could this be oil lever mechanism that is bad? any other suggestions
  3. T

    motor identification

    the motor identification on the mounting bracket is not readable. Is there another way to identify a 115 yamaha on the block?
  4. T

    2007 25 yama 2 stroke carb air adjustment

    how many turns out on the air adjustment screw i have a manual but cant locate the info
  5. T

    2006 mercury 225 warning horn

    put brand new wiring harness and smart tach i get a steady alarm and it goes away when i unplug high pressure pump installed new high pressure pump and the problem is still there
  6. T

    tach codes

    i have a 2003 90 tohatsu and its in limp mod does antbody know how to check the tach for the codes
  7. T

    idle air adjustment 2003 yamaha 70

    i have them set at 1 3/4 out but it will run 3/4 throttle but bogs down at wide open throttle i found them set that way when i clean the carbs
  8. T

    yamaha trp water pump replacement

    whats the white collar on top of the water pump
  9. T

    2006 150 evinrude etech want pump water

    changed out water pump and still want pump water
  10. T

    2010 90 evinrude starting problem

    90 evinrude that when you try to start it it runs for a second and dies over and over again
  11. T

    1994 25 mercury fuel pump gasket problems

    going to install fuel pump kit open the old fuel pump it has three gaskets ln it i go to the diagram and it shows two gaskets for that year model i also have a 2004 25 merc and it has three gaskets but look up diagram for 2004 it shows two gaskets so has anyone run into this before thanks
  12. T

    2006 25 yamaha 2 cyl idle air adjustments

    what is the number of turns out on the idle air adjustment
  13. T

    Gas in engine oil reservoir

    I have a 1999 200mag EFI mariner with gas in the oil is there a check valve some where to allow this to happen
See more
Back
Top