I noticed that my alternator w
I noticed that my alternator was not charging (via the voltmeter on dash). I also noticed that my purple wire broke off the lug.
Is it possible that the broken purple wire would cause my alternator not to charge?
My trim pistons are almost 20
My trim pistons are almost 20 yrs old and one of them sprung a leak.
Does anyone know where I can get a set of four without getting a 2nd mortgage on my house?
Does one need a pulley puller
Does one need a pulley puller to remove this pulley or will it slide off when I remove the raw water pump and the center bolt?
Thanks
"I have twin AQ271C. The curre
"I have twin AQ271C. The current setup has the fuel line going through a Racor R26S, then through a water separator (without bowl) then to the mechanical fuel pump.
In order to install my fuel flow meter, installation instructions say I need to be in-line after...
I am trying to figure out what
I am trying to figure out what the prop sizes would do for my cruising speed. I currently run B7's (DP-290) and at 3200 rpms I cruise @ 24kts.
What would a B5 or B6 do to my performance?
Are stainless props worth the extra money?
Thanks
"What is the difference betwee
"What is the difference between power trim and power tilt.
I have a 1988 DP-290, I hear them both talked about, but I don't know the difference neither do I know which one I have."
"Why do they do this?
The fee
"Why do they do this?
The feed for my instrument panel, ckt breakers was fed from a fuse that was tapped of the starter. My blower stopped working after a fuel fill-up and I noticed that everything else lost power too.
After troubeshooting, I found a loose...
The OEM sender has two lug pos
The OEM sender has two lug posts on them. The replacement sender I bought only has one post with two nuts on them.
I checked with the my local dealer and he can't find my original sender in the database.
Would it be alright to use the new sender and just...
"My hook-up fork is on its las
"My hook-up fork is on its last leg.
I'm probably getting another year out of it.
Is there an aftermarket grounding kit that you can install on them so when I eventually replace it, the new on won't get pitted to death?
Same for the hose connection, any...
Changed my bellows this spring
Changed my bellows this spring and the U-joints looked OK to the best of my knowledge.
How long do they usually last and what type of maintenance schedule are they on besides greasing the fittings?