Logo

Recent content by tigerjohn

  1. T

    2010 Merc 9.9 4stroke gas in oil...

    I have a 2010, 9.9 Mercury 4stroke tiller outboard. It started on the first pull after being in garage about 3 weeks ago. Went out perchin and it ran great. Went to hitch up this morning and noticed about a 3ft, still wet, gas spot on my driveway. Tried pullin once but it didn't want to pull...
  2. T

    2011 Mercury 9.9 hp 4 stroke

    I just got bought a new 9.9 hp 4 stroke and I have a question. When I put it in neutral I can spin the prop by hand freely in either direction. In Reverse it doesnt spin in either direction (CW or CCW). When I put it in Forward it spins freely in one direction only. It also makes a distinct...
  3. T

    2011 Mercury 9.9hp 4 Stroke problems!!!

    Still fairly new to outboards so please bear with me. Just purchased a new Mercury 4 Sroke 9.9 hp Model #1f10201fk. First time out was for about 15min. Followed break in procedures to the tee. Ran fine. About aweek later would not start. Took back to dealer and they said carbs were very finicky...
  4. T

    Ethanol Problems

    I am relatively new to the outboard motor market and am interested in YOUR opinions on gasoline that contains ethanol. Been hearing that it's in all brands to varying degrees. I've been told and actually shown what it can do to a carb. Also been told to always use Stabil or an equivelant. I am...
  5. T

    1969 fuel pump.

    Is there a kit to rebuild a 1969 15hp model #9922s, serial #E09832 fuel pump? If so where?
  6. T

    flywheel removal on 69 15hp evinrude.

    need to pull flywheel. Manual says to use evinrude puller tool. Is there another way? Dont have that tool.
  7. T

    1969 9.5 hp wont start!

    I have a 1969 9.5 hp Evinrude wont start. Has spark. Hooked fuel line to motor and primed bulb on fuel line. Noticed fuel leaking from fuel filter cap. Replaced cracked cap. Fixed leak. Didnt seem like motor was getting gas and wouldnt start. Removed Fuel filter/fuel pump assy and squeezed bulb...
Back
Top