Logo
FULL SITE MENU

Recent content by stop8

  1. S

    1991 Yamaha 115 V4 Tilt Dust seal replacement query

    Hi Folks, So I have a hydraulic leak from the dust seal of the tilt of my engine. I have tried to find info online but am struggling. All the parts diagrams from 1991 to 1996 show the seal in place but do not give it a part number. I spoke with one parts dealer that said it is not sold...
  2. S

    Yamaha V4 115BETO (95) overheat issue

    Ok so on further inspection I found bits of the old impeller in the thermostat so I cleaned them out and tried again. Now I have an overheat alarm without even trying to start the engine. I disconnected the thermo switch port side and the alarm stays on, disconnected the thermo switch...
  3. S

    Yamaha V4 115BETO (95) overheat issue

    Hi Folks, Recently acquired a 115 V4 Yamaha. Changed the impeller and the two thermostats but still have an overheat alarm. Took the thermostats off and checked them in a pan of semi boiling water and they open at 65 degrees as expected. Dropped the leg and repositioned to ensure the water...
  4. S

    Yamaha 115hp V4 (1995)

    Hi Folks, I have just purchased a Yamaha 115hp. It did not come with any battery connectors for the starter motor. I have some I can use but was not 100% on where the positive and negative should be connected. Is no 1 in the attached photo positive and no 2 negative..? Thanks
  5. S

    Tohatsu 90hp Automixing

    Hi all, I have a Glastron SSV-167. I am looking at a getting a second hand engine. I have three choices all 2 stroke. Suzuki 65hp, Tohatsu 90hp and a Yamaha 115hp. We use the boat for water skiing with the kids. I like the suzuki as I have had one before but feel it would be under powered. The...
  6. S

    Johnson 140 spark dwell handle

    pics follow
  7. S

    Johnson 140 Fuel Issue

    am 140 tlet
  8. S

    Johnson 140 spark dwell handle

    Hi I have a Johnson 140hp, V4, 1993. I was out this weekend and the engine began to loose power intermittently. It would work fine at tick over and low revs but there was no real power there when trying to accelerate. I took the cover off and noticed the spark dwell handle handle had worked...
  9. S

    Johnson 140 Fuel Issue

    Hi I have been investigating what I think is a fuel related issue causing a lack of power under load. The bulb won't get hard and the engine runs rough under load but starts fine. I have stripped the carbs for cleaning and was looking at removing and rebuilding the fuel pump. I noticed a small...
  10. S

    Johnson 140hp 1993, water pressure

    Hi I have a 1993 Johnson 140hp V4 and am installing a water pressure gauge. Can any one tell me the normal water pressure at tick over and at full revs? Thanks
  11. S

    Johnson 140 V4 model number issue

    Hi I have a johnson 140 V4 with a strange model number it is AM 140 TLET. Could anyone help explain the AM as all the dealers I have spoken to cannot identify this model? I have attached a pic to help Many Thanks
See more
Back
Top