Sorry if this had been asked before. I came across a clean intake manifold for a 340, looks the same as the one in my boat, came from a 68'.
I have a 74 340. Would these manifolds swap? They appear to be the same.
Hello, I have a good running 340 in my old 74' century resorter. I have done all of the exhaust manifolds within my ownership, they had a couple hairline cracks so I did it to avoid having more serious issues.
I am wondering if I should be thinking the same way about the intake manifold. It is...
I was wondering if someone could link me to a service manual for the 340. I have a 1974.
I had it but I can't find where I stored it.
Thanks in advance.
I cant remember what is up and down with this pump. i have an arrow marking up from last year but it doesn't seem right when I install it that way (the hoses get kind of kinked)
This orientation fits much better and looks right but I am concerned then i get it out on the water that I won't be...
I cant remember what is up and down with this pump. i have an arrow marking up from last year but it doesn't seem right when I install it that way (the hoses get kind of kinked)
This orientation fits much better and looks right but I am concerned when i get it out on the water that I won't be...
Hello, I have a new voltage regulator here from sierra. Diagram included is outdated and for the wrong part.
Here is a pic of what i have:
https://drive.google.com/file/d/0B34krHgTYkMocGdCcW5TYjhBYU5rTWV6UVZUemsxX3BsR0N3/view?usp=sharing
I just need to know what goes to what. I am guessing...
I have a 340 in a 18 ft century runabout. I have a single battery setup.
I was using a deep cycle die hard platinum series marine battery, cranked very slowly, but it worked.
The voltage regulator went on my last outing and I almost blew up the battery from over charging.
So I am now going...
I have a 340 in my old boat. When I removed the thermostat this year I noticed the manifold looked very pitted and rusty inside. I think I should replace it before I run into issues.
Any tips from those who have done it before?
Can I just use an Edelbrock intake manifold or does it have to be...
Hello. I finally sprang for a new Edelbrock 1409 for my 74' 340. The rebuilt original carter was holding up OK, but I am really tired of having an non-working choke and I figured I would try something new.
This was the carb that some of you guys recommended to me a couple years ago so it's...
I currently have a sherwood G5 with a 6.5" pulley on my 340.
I just came across a great deal and bought it.
Its a new sherwood G50 pump that I bought for 100 shipped on ebay.
The G50 has a 7.5" pulley.
Should I be worried about swapping out the pulleys? I now the g50 was used on 340's as...