Logo
FULL SITE MENU

Recent content by slk

  1. S

    Impeller for 9.8 Mercury

    I have a 9.8 Mercury that I need an impeller for. I see that ebay has some good prices on them. Do you guys think the ones on ebay are ok to use from vendors in this country??
  2. S

    Torque specks on Mercury 60 hp

    Ok guys I have removed the side plates from each side of this 1987 mercury 60 hp motor The exhaust/water jacket plate on the left side & the cover on the right side. What do I torque the bolts back to??? Thanks Steve
  3. S

    60 hp Mercury overheating

    Ok guys I have a 1987 Mercury 60 hp that over heats at high speed. Like over 4000 rpm's. It will not overheat at lower speeds. This problem has been gong for a couple years. This is what I have done so far. I have had 3 new impellers installed and that has not fixed the problem. I took the back...
  4. S

    Mercury 1987 60 hp overheating

    Guys I have a 1987 Mercury 60 hp that gets hot at full speed. If you just cruise at like 3200 rpm everything runs cool. I have replaced the impeller, and have a good stream water coming out. I am thinking of taking the rear cylinder cover off and checking the water passages for obstructions...
  5. S

    Minn Kota 565

    I need to know how to install the bearings in my 565. The top one is toast. Can I do it all from the top side of the shaft? Any help would be greatly appreciated. I see the cog wheel for the little chain to go around or the steering (pedal control). Under that is where the bearing goes. How do I...
  6. S

    1987 Mercury 60hp buzzer alarm

    I have a 60 hp engine 1987 that I just put a new impeller in. Water shoots out very good now. At FULL throttle only the darned buzzer alarm goes off. At normal speeds it never goes off. This engine does have the oil injection system. To be on the safe side I added oil to the gas and ran it and...
  7. S

    Impeller replacement on 1968 110 9.8hp outboard

    How hard is it to replace the impeller on this little motor? Any special instructions. I have replaced them on the larger mercurys. Just haven't on one of these little ones. Any linkage to disconnect? Thanks Steve
  8. S

    1968 Mercury 110 9.8 hp Manual

    Does anyone know where I can get a copy of an owners manual for a mercury 110 9.8hp motor. Just need the owners manual and not a repair manual, unless someone knows where I could get one of those. Thanks Steve
  9. S

    1987 Mercury 60 horse water pump replacement help

    I have watched several you tube videos of mercury water pump replacement procedures but none are there for the 60 horse. This is the three cylinder model. I only have 1 nut on each side of the lower unit and one in the very back. 3 total I think. Another question and the main one is there a...
See more
Back
Top