I wanted to buy a new crank f
I wanted to buy a new crank for a 115 hp Evinrude but at over 1000 bucks I now intend to repair the crank I have if it can be done. I has a small flake out of one of the rod bearing journels about 1/8 by 3/16 inch and about 1/32 deep.
Any advice would help
Sherm
I have run compression check
I have run compression check (120 on all cyl.). I switched coils and powerpack from left to right without any change. The number four cylinder still
does not fire at idle or until I get to about 2500 rpm. I rebuilt the carbs still no change. I did the 3/8 inch...
" I have a 1979 Evinrude 115 h
" I have a 1979 Evinrude 115 hp engine with one dead cylinder at low rpm. I think it is working ok at higher speeds. The compression is 120 in all cylinders but when I pull the plug wire off the number four cylinder it does not change how the engine runs. To...