Logo
FULL SITE MENU

Recent content by shawn

  1. S

    Main fuse breakage

    "I have a 1985 Mariner 90hp. "I have a 1985 Mariner 90hp. The motor runs like a top, but if I run it hard and open for awhile, like pulling a skier or tube, the 30 amp fuse breaks. Any ideas anyone?"
  2. S

    Help lower unit

    hi i just recently purchased hi i just recently purchased a century 21 foot bow rider and the lower unit got stolen how can i identify what lower unit i need.is there numbers on the uper unit?any help would be great.the boat is a 1979 with chevy 350 if that helps any
  3. S

    What year did evinrude make golden jubilee

    what year did evinrude make g what year did evinrude make golden jubilee?
  4. S

    What year is my evinrude

    i have a 35 hp evinrude lark i have a 35 hp evinrude lark golden jubilee edition. up until a week ago i thought it was a 1957 but now i think it is newer. can any one tell me what year is golden jubilee?
  5. S

    Steering

    ok so this is not exactly a m ok so this is not exactly a motor question but it is somthing i really need i need to know can i use pully steering to steer a 70hp 1974 johnson outboard???
  6. S

    Can i put a 70 hp and a 35 hp next to each other

    can i put a 70 hp and a 35 hp can i put a 70 hp and a 35 hp next to each other and use them at the sme time?
  7. S

    Hookup pullys for a 1959 evinrude lark 35hp golden jubilee edition generator

    help: i have a 1959 evinrude help: i have a 1959 evinrude lark 35hp golden jubilee edition outboard boat engine that has a generator but no pullys on the generator or the engine and it has no belt please help me if you can give me information on how it is hooked up or were i can find the...
  8. S

    Needed starter for a 1957 evinrude 35 hp outboard golden jubilee edition

    plaese help me i need a start plaese help me i need a starter for a 1957 evinrude 35 hp outboard golden jubilee edition and i dont know were to find one or if they are still made or how much they cost if you have any of this information please let me know thank you sincerly; shawn
  9. S

    1985 Alpha leaking lube from upper shift shaft

    " recently purchased 1985 chri " recently purchased 1985 chris craft scorpion which had not been operated in 2 years. After removing outdrive and replacing water pump and seals, lube has started seaping out of upper shift shaft. Is this a difficult part to reseal?? Cant seem to find any info...
  10. S

    1995 mercury 40hp 4cyl

    " Is there such a thing as a 1 " Is there such a thing as a 1995 40hp mercury pro series motor? If so, what is different with this motor then a regular 40hp? thanks shawn "
  11. S

    196x 18hp evinrude fasttwin carb

    " I have a 18 horse evinrude a " I have a 18 horse evinrude and i stated dumping gas all over. shut it off and pulled the hood to look and there was a larger screw laying in the case, it was from the very front bottom of the carb where the fuel was pouring out. I put the screw back in and now...
  12. S

    Stabilizer plates hydrofoils do they work

    " Im looking in a magazine and " Im looking in a magazine and see the Cobra edge, SE Sport, Sting Ray, Davis Doel Fin and so forth, do theese actually work? I have a 14 foot crestliner 20" transom, with a total weight of about 1100 pounds with the two of us, 850 pounds with just me, gear...
  13. S

    Help with HP Ratings

    " I am confused, I have what i believe is a 1962 Evinrude Fastwin 18hp longshaft, Im looking for a new motor that performs as least as well or better that the 18 on my 82 Crestliner Commodore 14foot boat, it weighs about 300 pounds. I want to keep the motor light and its used strictly for...
  14. S

    Ford 351 Indmar wVelvet drive

    " I have a 1993 Shamrock Warri " I have a 1993 Shamrock Warrior with a Ford 351 engine marinized by Indmar. Last week the oil pan "sprung" a leak due to corrosion. I have to pull the engine to replace the oil pan. I figure since I'm having to do that, I should install new engine and...
See more
Back
Top