Logo
FULL SITE MENU

Recent content by RLI01

  1. R

    BF50 2006.....Cylinder #2 not firing....

    Hi Honda buds Older Honda 50 ....no instruments Its been running slower recently (sounds good at speed) idle quite rough tho.....installed brand new plugs..... I pulled all three plug leads individually and cylinder #2 made no change to running engine. Tried to test for spark by grounding...
  2. R

    BF50 2006 Oil Leak from top of engine/crank shaft under the fly wheel .....

    Got it done ...... thx so much for your help ...⭐️⭐️⭐️⭐️⭐️'s
  3. R

    BF50 2006 Oil Leak from top of engine/crank shaft under the fly wheel .....

    .....waiting on new seal delivery
  4. R

    BF50 2006 Oil Leak from top of engine/crank shaft under the fly wheel .....

    I removed the flywheel today to access the locknut on the crankshaft ..... I measured the locknut with calipers and got 56mm ...I looked up said locknut on Honda Marine parts and it said 48 mm ...... Do you know what socket size as I have to order it off Amazon..... could not find it locally
  5. R

    BF50 2006 Oil Leak from top of engine/crank shaft under the fly wheel .....

    Interesting... thanks Alan I did a pressure test bout 6 months ago... all good but will test tomorrow again To change the seal ..... remove fly wheel ..... pull seal and replace .... straight forward or do I need tricks/tools I'll keep you posted ..... 😎 I did compression test and all three...
  6. R

    BF50 2006 Oil Leak from top of engine/crank shaft under the fly wheel .....

    Hi fellas New oil leak from top of the engine (under the fly wheel) when full throttle.......no leak at normal speed. Engine running great otherwise...... Oil seal done ....? Can I easily replace ...? Please council me on this fellas .... If it is a major breakdown to replace should I do...
  7. R

    Honda 50 2005 Running a little Rough

    Hi All My Honda 50 outboard started running just a little rough - not by much but when it usually runs smooth as silk I noticed it right away. I have new gas filter and run a gas/water filter too. Regular oil change also. I live in SC low country and have seen the commercial oystermen run...
  8. R

    Water Pump Change

    Hi y'all 2005 Honda 50 - runs like a scalded cat but its time to change the water pump - I purchased the kit from Honda plus new thermostat. I have found a few tube vids on the subject but none covers the lower removal Any tips ? Hondadude was most gracious and kind with my last minor...
  9. R

    Hoda Marine Throttle Control Question

    Hi All I need to replace the trigger on the throttle handle on a Honda Marine control I took off the side cover and am afraid to touch anything as it looks like a can of worms has anyone done this before? Any tips would be appreciated many thanks Thanks Simon
  10. R

    Honda BF 50 Throttle Control Unit parts and maintenance and service

    Hi yall I have a '05 Honda BF 50 (runs like a scalded cat - idle a little high) The motor is controlled by a side mount Honda throttle control - stamped number 502560 Yesterday broke the squeeze trigger used to engage the throttle lever forward and reverse. Where do I purchase the parts...
  11. R

    '05 BF 50 Tilt n Trim removed

    Hi All I have a 05 BF 50 the T n T was leaking oil on the water and struggling I removed it for repair ( more on that at a later date) I was hoping to use the boat (Jon Boat ) in the mean time without the T n T but the engine will not start not a peep Do I need to rewire or connect...
See more
Back
Top