Logo

Recent content by Rick_B

  1. R

    Pontoon Boat Light Operation

    Good afternoon - I have an 18' pontoon boat with a white stern light and a red/green lights on the deck front. I had them all disconnected for a floor replacement and now I'm not sure how they should operate. The light switch is two position and I THINK in one position only the stern anchor...
  2. R

    Remtoe Control Install

    Good evening - I have a 2000 60 HP 4 stroke Mercury motor on a pontoon boat. Last fall I disassembled the console to remove t for a new floor installation. Part of that disassembler involved the remote control for forward/neutral/reverse and throttle. Well now I''m re-assembling and can't...
  3. R

    Pontoon Boat Floor Flabnge

    Hi - I'm looking for a source for a flange/grommet that goes in the floor of a pontoon boat under the console. This is the access for the the wiring harness from under the boat. Thanks Rick
  4. R

    Winterizing Help Please

    Up to now I have had a 90 HP mercury and generally gfollowed the user manual guidelines. This year have a 120 HP Johnson V4 to winterize. I did buy the manual but I am lloking for some verifcation thatmy plan is OK. I plan to pull the prop, clean and grease it andreinstall, changethe lower...
  5. R

    Need Help with Aluminum Boat Hull cleaning

    Good afternoon folks - I'm new to this forum but am hoping I can get a little help. I have a 1991 Star Craft 19' deep V boat. It is new t me this year. It has been docked in the water (river in upstate NY) for the last 5 months. I pulled it yesterday and it has a lot of hard water build up...
  6. R

    Steering Question

    Good morning folks - I have a 1991 Johnson 120 HP V4 engne on a 19' starcraft center console deep V boat. I've noticed a significant "pull to the right" as I'm running down the lake at a slow to moderate speed. Is there a reasonable easy adjustment for this in the steering linkage system...
  7. R

    1991 Johnson V4 Cooling

    So I'm finally getting to the point where I can put my new to me starcraft 19' deep V with a 1991 Johnson V4 in the water. Because it s new to me I wanted to start it out of the water first using a flushing device (earmuff). The motor started fine however there was no water being ejected at...
  8. R

    New Guy With a Question

    Good afternoon folks - I recently bought a 1991 starcraft boat with a 1991 Johnson outboard(120 HP V4). It had an intermittent tilt/trim issue where it would operate in the down cyckle but not in the up cycle. the Previous owner indcated that if I tapped the outside of the junctin box (in the...
Back
Top