Logo
FULL SITE MENU

Recent content by offthepath

  1. O

    No alarm

    On our 2006 350mpi we replaced the engine with a 383 and had whipple reprogram the 555 ecm. We ran the engine on the stand without any issues. The engine is now in the boat and with the key on, the alarm is not coming on at all. Even after several minutes. Fuel pump cycles, but we have not...
  2. O

    Transom seal

    Have the engine pulled on our bravo 3 boat. It has had some kind of leak since we purchased the boat, so I am replacing any seal I can, including the transom seal. Question, should I use 4200 or some kind of sealant on the foam transom seal? The prrvious one appeared to be installed dry, but...
  3. O

    Running engine on stand, out of boat

    Installing a new 6.2 mag mpi bravo and would like to run the engine before dropping it in the boat. Is there any special considerations, wiring etc, problems with codes from things not being hooked up, etc? I was planning on running a hot and an indicator for the oil pressure light. Any...
  4. O

    350 MAG MPI hard start issue

    I have an 06 Crownline 240EX with a 350 Mag mpi bravo 3 (OW375597). I purchased the boat last fall and we have been having a nagging hard start issue. The boat starts right up on the first start of the day, but after that the boat needs 1/4 throttle to start. It does not seem to correlate...
See more
Back
Top