I have a 1992 sportcraft with a 4.3 of same year. Read somewhere that later 4.3 had a counter balance shaft to make it run smoother.
Can anyone tell me what year they started doing that, and how to identify such an engine ?
Looking for wiring diagram for the digital trim system used with the DP-C drive in the early '90s.
I have the owners manual for the drive, and it has a basic "block" diagram, but I need a full "pin to pin" diagram to verify the wiring. I stumbled across a very clean gauge for that system ( the...
Have a '92 DP-C with the digital trim gauge not working.
Does anyone know if there's an analog gauge that can be made to work with the sender for the digital system ? Or any other fix for this ?
Thanks
Ted
Installing new shift cable, need to know if I should go over or under water intake hose. Over hose puts cable in a bind, under hose is almost impossible. have the plastic water neck and molded hose.
Any one been here before ??
Ted
My system didn't work when I tested it today, took it apart & found the solenoid stuck and corroded. I'm adding a flush hose input to the water input hose now that the boat is on a trailer, and I'm wondering if I should fix and retain the neutra salt system.
I'm looking for input from neutra...
Greetings:
I have a Sportcraft 232 WA/CC, with the VP 430/ DP-c drive, and the trim gauge (round,digital) is shot.
There is the digital round version 856-813, and an earlier square version that has the same display, but in a sq package.
The VP owners manual for the round version shows a round...
Hello all; this is my first post on this forum, so please bear with me as I don't know all the proper terms for some parts.
The raw water intake from the o/d comes in thru the transom plate on the port side as a 1.5" hose nipple. Ahose is connected there, and runs fwd to the input of the pwr...