Logo
FULL SITE MENU

Recent content by Midwest fisher

  1. M

    BF45A help needed

    Boat belongs to my farther so neither of us has seen it run on the water. Carbs were filthy but it did seem to idle better last year possibly due to the intake being filled with mud dobber nests restricting airflow.
  2. M

    BF45A help needed

    Been around the intake and carbs with carb spray to no avail. Just putting my hand up the the air intake muffler without even really trying to close off the air seems to make the biggest difference. There is a very large opening screen in there just thinking I am missing something simple like...
  3. M

    BF45A help needed

    Seemed to help but still too lean at idle. I'm starting to wonder if there is a screen missing from this engines muffler cover. Does anyone have a picture of there inside of both sties.? Looks like bf40 and bf50 shared the same muffler cover. Mine only has one large grid screen in it.
  4. M

    BF45A help needed

    Thank you, that 11.5 mm seems like around the way I found the floats initially. I'm sure the circuit passages are clear but cannot in good faith consider removing the carbs for float adjustment without blowing out all passages again. Will advise.
  5. M

    BF45A help needed

    Pulled boat from storage and carb problems from old fuel. Went through carbs and emulsion tubes and jets are clean now with no cracks but engine won't run without choke. I went back into the carbs as this just sounds like a plugged jet or emulsion tube but no. No vacuum leaks. Funny thing is it...
See more
Back
Top