My motor has a leaking lower unit seal and the mechanic (honda dealer) can't get the nut off. Any good ideas or go-to mechanic or machine shop in the Annapolis area. The case isn't cracked...yet.
If there any way to check/change the gear lube in a 40 hp with the boat in the water? Everything I've read shows it being done with the motor vertical which puts the lower underwater.
Prepping the boat for the hurricane and when i tilted the motor up some oil ran out. Looks like a small pool at the base of the power head below where the dip stic goes in. No time to troubleshoot but where should I look when I get back to the boat. Oil level looked ok, maybe even a little...
Motor is a 98 BF40A, starts ok but runs rough, needs choke on and fast idle arm up or it stalls. If I use the manual choke I can advance the throttle and it speeds up. I think it needs a carb cleaning but the mechanic at the marina says it needs a fuel pump. When it's running I can squeeze the...
I want to add a temp gauge and water pressure gauge to my 2006 40hp motor. My instalation makes it hard to see the teltale and i don't trust the idiot light. Is there someplace to install the sensors without removing the current temp sensor.