Logo
FULL SITE MENU

Recent content by Mdhanners

  1. M

    Tachometer incorrect readings

    I know its not the little round 3 wire typically found on Omc. How is best way to check the input to my tach from Grey wire coming from the motor wire strip. Haven't found the specs to check what the Grey wire to ground with multimeter should read with engine running.. Hopefully you know or...
  2. M

    1995 Evinrude 175 Bad Rectifier

    Question was your tach the problem I have this same issue that didn't read any more than 1100 rpm then when I attached Grey wire to the yellow with Grey same thing 1100 only but I just attached Grey to the strip on motor left the two yellow /Grey stator and rectifier wires on the strip maybe...
  3. M

    Tachometer incorrect readings

    . 97 Johnson 70hp 3 cyl with vro connection. At idle tach reads fairly well off idle bout 1100 rpm is max it will read. Also the volt meter pegs over 18v once key on engine off. Running battery voltage is apx 13.6 Key off battery volts is 12.7 normal.. I pulled the volt meter tested the Blue to...
See more
Back
Top