"I am looking to buy a new roa
"I am looking to buy a new roatary steering kit. I have removed the old cable and helm, and removed the cable from the helm. My question is when sizing the cable do you measure the cable that was wound up inside the helm? Or, do you measure from the large nut...
"I have a 1977 Johnson Seahors
"I have a 1977 Johnson Seahorse 35 HP outboard 2 stroke. During the winter is there a limit to how cold of water is safe to operate in? Is there a risk if the water is to cold that it could crack the powerhead? The water is drawn up into the powerhead by the...
"I have an 1977 Seaswirl 15
"I have an 1977 Seaswirl 15' with a 35 Hp Johnson. The steering wheel is very hard to turn. Does anyone know what kind of steering was installed on this boat? I think it is a cable type steering. Why is this so hard to steer. The only place I see to lube this...
"Does anyone have the part num
"Does anyone have the part number for the starter selenoid for a 1977 Johnson Seahorse, 35 HP, MDL# 35EL77C?
Thanks,
Mike"
"I have a 35 hp 1977 Johnson S
"I have a 35 hp 1977 Johnson Seahorse. I recently rebuilt the lower unit. The used lower unit housing that I put on has some chipping paint. Do I need to install some zinc on the cavitation plate to prevent corrosion? Where is the best place to install Zinc in...
For the 2 seals that are insta
For the 2 seals that are installed back to back below the water pump on a 1977 35HP Johnson seahorse. Is there a difference in the seals? I have new ones. 1 of them has an O-ring on the outer edge. Which one goes face down and which one goes face up? Does it...
"Does anyone know the part # f
"Does anyone know the part # for the upper drive shaft bearing fo a 1977 Johnson Seahorse 35 hp mdl# 35EL77C? This is the bearing that sits under the water pump with 2 seals above it. 2nd, is there a good tool for installing the seals? 3rd, I am looking for a...
"I have 2 1977 Johnson seahors
"I have 2 1977 Johnson seahorse 35 HP mdl#'s 35EL77C & 35EL77H, I just bought the 35EL77H. It runs strong, but when it was tested in the tank. The water that sprays out from below the powerhead would flow good at first. Then stops after a minute or two. Same...
"I am trying to rebuild a lowe
"I am trying to rebuild a lower unit for a 1977 35 hp Johnson. I am having trouble removing the bearing carrier seals.. The seloc repair manual says that there are 2 seals installed back to back. I do not see this. I have a rubber seal piece with a metal...
"What other kinds of lower uni
"What other kinds of lower units will work with a 1977 Johnson Seahorse 35 HP, mdl# 35EL77C?
Evinrude?
Merc?
or any others?
Does it have to be a Johnson lower unit?
Thanks,"
"Does anyone know which other
"Does anyone know which other models, years, and HP lower units would work with a 1977 Johnson Seahorse, 35HP, model# 35EL77C? I have a broken prop shaft. Dont know if it would be easier to find a rebuilt lower unit or replace the shaft. Will the 25HP lower unit...
"I am having trouble getting m
"I am having trouble getting my lower unit off. I need to replace the prop shaft. I have removed all the bolts that I can see holding it on. Also the shift shaft bolt. It is loose toward the back, but does not want to move toward the front. Is there a trick...