2005 J15 2 stroke.
Does anybody know the exact location of pn 345188 (#5 in Cylinder diagram). Its a water passage grommet. It looks to be near exhaust cover. I pulled the cover and dont see it.
I ve got a hot head at higher RPMs only and already gone through the cylinder head, pump, t stat...
I’ve got a 2005 Johnson 15 2 stroke that runs hot. Pulled the head, exhaust cover and powerhead to change tube grommets. New thermostat and pump. Still get over 230 f on the head. The block is corroded around the outside of the cylinders pretty bad , missing chunks.
thinking I’m just going to...
Anybody replace p/n 0584840 charge coil and lamination (discontinued) ? Aftermarket coil ( CDI P/N: 173-1670) available but have to swap the lamination.
Directions are a little hard to follow. Says fold top lamination up and bottom lamination down to secure coil but having trouble picturing...
Pulled the leg and impeller looked ok. Water pipe and fitting looked ok. Tell tale hose is not blocked. Was working fine when put up in the fall. Just cleaned the carb. Water was coming out the prop when on muffs. Also ran in tub. Water coming out of the week how in extension. Exhaust is going...
Advice needed: bought 2006 J15 in 2012, PO said fresh carb cleaned/ serviced. In 2016 had issue with stalling in gear at idle, then hard to start, wait ten minutes and will restart and fuel leaking out of carb. Ended up changing the float and seat and doing a quick clean and blow dry. Fixed it...
Leaking out of thermostat cover. So planning to replace thermostat and the cover seal. Do you guys add additional sealant ( like a high temp gasket maker/ rtv)?
Ive got a WOT hesitation with backfire/ spark knock that I can't figure out.
It's a TBI. I've checked the fuel pressure. Ran off portable tank. Both fuel filters are new. Distributor cap, rotor and plugs new last year. Plug wires new. Checked the timing.
I've got a EFI live data scanner...
Ordered a new prop for my 15 hp 2 stroke. Went with a Solas high thrust 10x5 4 blade.
But the back of the prop is touching the lower unit when I tighten it down.
Has any one used this brand?
they sell a hardware kit I quess I can try. I figured I could just use the thrust washer and spacer...