Good one to check, but the motor is used daily, so there is little chance at getting set up in there. However they do like building around our house.
Mike
I can get up to 2,100 rpm out of the drill. After attaching a clear hose between the waterpump (in the lower end sitting in water) and the discharge tube in the drive shaft housing, I could see the water entering the motor. The water exited the driveshaft housing through the bottom, but none...
I was wondering if I could get some feedback on how much water should come out of a water pump. While trying to find a low flow problem in a 30 hp Merc 4 stroke, I am at the beginning again looking at the waterpump. The lower end is in a test tank and I am spinning the output shaft with a...
Greetings All,
I have a 30 hp Fuel injected from 2016 that has no Pee Stream (I have no better term for this one). It sits in Fresh water and gets idled around every day; unfortunately it can not run faster than 5 mph. After no maintenance for 7 years, the owner needed it fixed a week before...