Logo
FULL SITE MENU

Recent content by limige

  1. L

    81 90hp tilt unit wiring

    picked up this motor last year for our boat. wiring was trashed for the tilt, it needs to be replaced. this unit had the box with the large solenoid inside it. any chance I could update this to a setup using two small relays instead of the bulky box? motor is a 3 wire, i'm assuming ground, up...
  2. L

    '71 318 cooling probs with duel imp pump

    hey guys. got a problem, fried my impellors when i left the water inlet closed from last winter. boat is a 71 penn yan, raw water cooling rebuilt the D65 pump with new impellors, put it in the water and it got hot idling. pulled the pump apart and toasted one impellor. so i replaced it...
  3. L

    318 oil change and velvet drive

    "i have a 73 penn yan, what a "i have a 73 penn yan, what a pita changing the oil is, i had to remove the dipsticktube and try to hold the rubber hose at the bottom while pumping.. i tried to tape a piece of coathanger on it but it wouldnt' fit through the hole. managed to get most of it out...
  4. L

    Thunderbolt ignition mercury 115rotor help

    "got an old 77 115hp merc that "got an old 77 115hp merc that hasn't been run in 5 yrs. i replaced the impellor, plugs, and was getting ready to change the cap/rotor/wires when i ran into trouble getting the rotor off. ended up busting it off to find out it wasn't made to come off. now...
  5. L

    Parts interchange manuals

    just curious if there is such just curious if there is such a thing. i'm wondering what other powerheads would fit on my 79 115hp.
  6. L

    Anyone got a spare piston

    "i need a piston for my 79 115 "i need a piston for my 79 115 model 1157H9B gaskets were bad enough, anyone got a stock bore takeout piston they wouldn't mind getting rid of cheap???"
  7. L

    79 bayliner penta outdrive tilt problem

    "hi guys, i got a 79 bayliner "hi guys, i got a 79 bayliner saratoga from my cousin, the release for the tilt keeps breaking the pin where it meets the wormdrive plunger. i can't figure out why, anybody familiar with this problem? any tips/solutions?"
See more
Back
Top