I've been battling this for a while now... any advice would be gratefully appreciated!
Problem: Not enough water pressure (doesn’t get any higher than 12 psi on the gauge even at WOT) and boat runs at 200 degrees when mid to WOT. I have both temp and pressure gauges. Alarm has not gone off...
I've been battling this for a while now... any advice would be gratefully appreciated!
Problem: Not enough water pressure (doesn’t get any higher than 12 psi on the gauge even at WOT) and boat runs at 200 degrees when mid to WOT. I have both temp and pressure gauges. Alarm has not gone off...
I have a 1998 150 XL Merc. and have been trying to install a water pressure gauge with no success. There does not appear to be any dedicated port for a such fitting into the cylinder head. I ended up tee'ing it into the tell tale tubing but I get no pressure reading whatsoever. I would love to...
Help! I have a 1998 Merc 150 XL. Having alarm issue. Must be temp since I've pulled the oil injection and mix my fuel/oil in tank.
I replaced the thermostats, new water pump, replaced poppet valve -- just now replaced the temp. sensor, but still getting the alarm... Engine has a good stream...
galamb, I think you might right on this. I went down to the boat to see where the poppet valve was located. Going to order the part and replace. Hopefully it will solve my issue. It appears I will need to remove the lower cowl on the engine. Pretty easy process? Can't seem to locate any...
Hoping to get some help as I'm new to this forum as well as the engine!
I have recently purchased a 1998 Mercury 150 Outboard (Offshore). I have a long (continuous) alarm that will go off after running the boat at 3 /4 – full throttle for longer than 5-10 minutes. I can run the boat at low...