Logo
FULL SITE MENU

Recent content by keverno

  1. K

    AQAD41A raw water hose size

    Can anyone confirm that the inlet raw water flexible hose that runs from the fitting on the transom plate, in my case on starboard engine to the power steering cooler in then on to the brass pipe that fits into the raw water pump has an inside diameter of 1” (inch) I am overseas at the Sydney...
  2. K

    290DP Stern Drive Steering Fork/Arm issue.

    AQAD41A engine with early 290-DP drive. I recently purchased a new steering yoke kit with protection cap P/n 873183 as the sealing ring had let salt water past and had badly corroded the steering shaft just below the spline where the steering arm mounts on. I had Volvo Penta certified mechanic...
  3. K

    Sea water pump O ring size

    Does anyone know what the O ring size is on the newer single piece housing raw water pump is, as used on my 96 7.4L engine with a Bravo 2 leg I believe the water pump kit part number is 46-807151A14 and the if you buy the separate O ring it's number is 25-33465 I went to replace the impeller and...
  4. K

    74L Bravo II 2 Piece Raw Water Pump Replacement

    "My plastic housing on my 2-pi "My plastic housing on my 2-piece seawater pump is looking a little worn. I note that this part is no longer available and has been superseded by a complete one-piece pump conversion Mercury kit part number 46-807151A14. Does anyone know what material Mercury kit...
  5. K

    Bravo Two Swivel Shaft Removeal

    "I was about to fit a new set "I was about to fit a new set of bellows to my 1996 Sea Ray 270 - 454 Mercuiser, when I discovered that the upper swivel shaft was starting to seize, with also some evidence of corrosion in this area as well. I have purchased a Mercury access plug kit to fit to...
  6. K

    1996 Mercuiser 74L Ring Set

    "Earlier this year I purchased "Earlier this year I purchased a 1996 Searay 270 with a engine that had sat for quite sometime and when the last owner started it to demo to a buyer it had 3 hang exhaust valves which them caused it to suck in some water into 3 cylinders, he had the heads removed...
See more
Back
Top