Issue happened when I was on the water after changing alternator just reattached exsisting belt . then engine lost power like out of gas and then i looked and all belts were off pullys with all this black belt stuff on the engine - Only belt left good was the Pw sterring belt -- Shreaded and...
25 Foot Express Cruiser Sea Ra
25 Foot Express Cruiser Sea Ray- 454 Bravo1
I just had the boat out a few times and the last time the engine starter sounded funny so I took a look and it was loose and broke 1 of the bolts off holding it in? Not sure why it would lossen up? So pulled the starter...
I have had to change props bef
I have had to change props before on a Alfha 1 -- Now I have a Bravo 1 and not sure whats going on but there is a sleve over the nut on it and not sure how to remove it?
I want to send a pic but do not no how to upload ?
John
I have a 94 454 Mag with a Bra
I have a 94 454 Mag with a Bravo 1 - I am looking at replacing the impeller on the seawater pump. -Can this be done without removing the sea water pump from the engine? It has the fuel pump on top of it and was not wanting to mess with that and Vbelts---
The pump...
My Engine Water temp gauge is
My Engine Water temp gauge is not working? Can the Gauge be checked or tested to see if it is working or a test to check the sending unit?
Thanks
John
I just purchased a Sea Ray wit
I just purchased a Sea Ray with a 454 with 440 hrs- It has always been servied at a Marina and looks like they used Straight Chevron 40 wt -- Engine has no leaks and good Oil pressure.
Is there a concern to use Synthetics on a older engine?
I am thinking...
Can someone tell me how many q
Can someone tell me how many quarts of oil to use with changing the filter in a 5.7 Model 270 GM Crusader engine - . Also what would be normal oil pressure -- My engine seems to run very High 80 psi at 3000 rpm? - Can this happen with to much oil being added to...
Engine will not turn over-- ma
Engine will not turn over-- makes 1 click noise when key turned to start- I thought it was the solenoid by the circuit braker on the manifold Click noise coming from there?- but replaced and still makes 1 click when trying to start-- Battery is charged and good...
Engine will not turn over-- m
Engine will not turn over-- makes 1 click noise when key turned to start- I thought it was the silnoid by the circuit braker on the manifold Click noise coming from there?- but replaced and still makes 1 click when trying to start-- Battery is charged and good...
"I have a 21 foot Cudi cabin 4
"I have a 21 foot Cudi cabin 4 Winns I/O 5.7 260 Hp Alpha One out drive , What propeller should be used for all around use , I have a stainless 14" with a 19 pitch, 48-16316 A4 19, Should I be using a higher pitch ?"
"I just had a rebuilt 1985 5.7
"I just had a rebuilt 1985 5.7 put in and found out after installing everything that the valves need to be adjusted because of the new Hdy lifters and it also seems to be no oil pumping up thru them?. Its the older style motor were the bolts for the valve covers...
"First Off I appreciate all yo
"First Off I appreciate all you guys help!!
I am looking at a 85 GM 5.7 rebuilt engine that is complete and was a inboard motor. I am replacing a 94 mercruiser 5.0 LX Alpha 1. The outdrive is OK and is a Alpha 1 gen 2, Should be OK to run with the 5.7
It looks...