Logo
FULL SITE MENU

Recent content by jordan

  1. J

    ACCELERATOR PUMP

    "I have a volvo penta AQ131 WI "I have a volvo penta AQ131 WITH A SOLEX 44 PAI CARBURETOR, runs fine, but when you pull a wake boarder up from a dead stop to full throttle it starts stumbling, hesitating for 5-10 seconds before kicking in. A slow acceleration is fine. Does someone know if that...
  2. J

    What year is my 98 Mercury

    "Blue band serial # 7195715 I "Blue band serial # 7195715 I need to get a manual, can anyone help? Thanks Dave"
  3. J

    Upper gear from the intermediate housing

    "Can't seperate the upper "Can't seperate the upper gear from the intermediate housing. I have removed the fastener from the steering helmet, removed the shift cover, the shift cable, disconnected thecable from the shift mechanism, removed the locking plate, unclamped the u-joint bellows...
  4. J

    U joint

    "I want to replace the u-joint "I want to replace the u-joint on my 1986 bayliner, it has a volvo penta 2.3 AQ131/275 I have never done this, does anyone know of a good website or any info that would help this rookie? any help or suggestions would be helpfull. Thanks, Dave"
  5. J

    Help Joe 1992 Evinrude 15hp

    " I can`t get my motor to idle " I can`t get my motor to idle. We changed s/plugs and clean the carb. But it will not idle and the only way to get it to idle is to start it up and quickly shift it into gear and open the throttle. Also what is the correct gap for the s/plugs. Thanks in...
  6. J

    Torque settings 1992 Evinrude 15hp

    What is the correct torque se What is the correct torque setting for the flywheel nut. Thanks for any help. Jordan
  7. J

    Carburetor1992 Evinrude 15hp

    " I`m in the process of removi " I`m in the process of removing the carburetor on a 1992 Evinrude 15hp for cleaning. My question is how is the best way to remove the right-hand side mounting nut. Is it best to remove the flywheel, the recoil starter or both. Any tips will be helpful. Is there...
See more
Back
Top