Logo

Recent content by Jerry T

  1. J

    vacuum switch bringing on engine light only at start up E175EXECD

    What would you look for at this problem...I put a small pressure on hose of vaccum switch and the engine light did not come on When it starts it comes on and then resets and every start after that is good no engine light . Only after it sits for a while does the vacuum switch bring on the...
  2. J

    solid alarm for about a min chk eng lite on then goes out when i start the boat model E175EXECD

    I have read the trb shoot section of the book and it leads to fuel problems . I just went through the entire gas section new hoses check valve pk up in tank new vro pump ....out of ideas and dont have a way to read the lights no flashes when i turn the key on ...Can any of you guys with...
  3. J

    idle mixture screw adjustment on a 175 hp evinrude

    I just finished the rebuild on all six carbs on a 175 hp evinrude. It seems to run pretty good but I was reading the manual and it says to srtart at 4 turns . Then wait for it to warm up and adjust until you get the best idle...It dont seem to change much do any of you pros have a didfferent...
  4. J

    VRO Pump

    I have a 1998 175 hp Evinrude with VRO....I was having so much problems with blue smoke, I converted the engine to mix my own. After reading a forum here regarding the common issues of the VRO system I have decided to replace the system back to as built...Heres my question...I have right now...
Back
Top