Logo
FULL SITE MENU

Recent content by hugo

  1. H

    KAD32 water temp

    Hi: My KAD32 reading 103C in W.T.O(3800rpm), is it correct? When the rpm go down, the temp go down too,(about 80C).THX.
  2. H

    Ujoint Bellow retainer sleeve

    "Hi All:I have a Alpha one GEN "Hi All:I have a Alpha one GEN II sterndrive, I found the U-joint bellow and exhaust bellow has broken, I worry the gimbal bearing and U-joint will corrode so need to change, but the both side of the exhaust bellow are use claim, that I know how to install, but...
  3. H

    Drain system

    "This is a 92'Mercruiser 4 "This is a 92'Mercruiser 4.3LX, I drain out the water from cylinder and manifold each times after use. Now, I wondering if it will easier to corison beacause it is empty inside."
  4. H

    1992 43V6 turning over slowly

    "I have a mercruiser 1992 4.3 "I have a mercruiser 1992 4.3 V6 in my Searay Sundancer230.I didn't use the boat about 4 years, Now, when I restar it again with a fully charge battery, the battery gauge show 12V, but the engine didn't turning over, just only say"Ta...Ta", Even remove all the...
  5. H

    1992 43V6 turning over slowly

    "I have a mercruiser 1992 4.3 "I have a mercruiser 1992 4.3 V6 in my Searay Sundancer230.I didn't use the boat about 4 years, Now, when I restar it again with a fully charge battery, the battery gauge show 12V, but the engine didn't turning over, just only say"Ta...Ta", Even remove all the...
  6. H

    RePainting a aluminum boat Help

    " Hello, Does anyone know w " Hello, Does anyone know what kind of spray paint I should use to repaint a flat bottom aluminum boat? Is there a special marine boat paint or can I use some Krylon or Rust Oleum? I just don't know what kind will hold up best under the water line. Any...
  7. H

    25 HP Evinrude Oil Mix and Year

    " I have recently acquired a 2 " I have recently acquired a 25 HP Evinrude "Whispering Power" Aquasonic outboard. First off, what oil mix should I use? (Someone has told me 50:1 but I would appreciate other opinions as I don't want to blow it up.) Secondly what year is it? I can't find a...
  8. H

    Question on 12hp OMC Attn JoeReeves

    " I got your message. Thanks. " I got your message. Thanks. The motor is an old one which has been painted over. The guy at the auction said it was an omc, but I cannot find it anywhere. I did find the model and serial numbers though. Maybe this would help you identify the proper mix. Model...
  9. H

    Oil Mix ratio for an old OMC 12 HP

    I recently bought an old 12 O I recently bought an old 12 OMC at an auction. Does anyone know the oil to gas mix ratio? Your help would be greatly appreciated.
See more
Back
Top