I need help figuring out why my outboard 75HP 2002 Merc trims down by itself when I rev RPM up to go on plane and will not trim up at all. When I idle or motor is off trims up and down just fine. It was working fine before and just started having this issue. I tried trimming up motor then throw...
I'm thinking of buying a used 2001 75 HP Mercury 2 stroke with oil injection. the compression on all three cylinders is 120
Are these outboards reliable and worth paying the $2500. ?
I have a 1995 40 HP Force outboard and want to know if the lower unit and other parts like Solenoid, Starter, Carb and Stator, Etcetera will fit and work on a 1997 40 HP Force..?
I heard Mercury outboards from 1990's that are 70 HP to 120 HP can use same parts (are compatible).?
Is it the same...
I tried starting my 15HP Mercury for the first time a almost 2 years. I pulled the choke once and then a second time. I pulled the cord and the motor started but only putt putted about 30 seconds and stopped. I turned the choke button toward the right to the Fast where it also says Start and...
I've decided to replace the power block from my outboard 40 HP Force 1995 serial OE120622. It's the first time doing this mechanical work now that I've stored my boat for the winter. I'm now going to rent a lift to take off power block but having trouble finding information where to hook the...
I changed the head gasket to my outboard and now only one bolt (bottom left) does not fully tighten but is very snug. All other bolts are tighten well. Will this one bolt cause cylinder problems for me.?
One bolt thread on my Head Crankcase is stripped and want to use Loctite Stripped Thread Repair Kit 12.9ml, Gray Form A Thread.
Can anyone tell me if this is will work? The bolt is lower and will not be able to drill to put in a Helicoils.
I'm replacing the head gasket to my 1995 40 HP Force 2 Stroke outboard and need to know what is the Torque specifications to tighten the bolts.
I've search the internet many places and can't seem to find the Lbs of torque I need to tighten the bolts. Can someone please help me.?
I have a 1995 Force 40HP and while changing the lower gear unit oil observed a streak of milk white streak come out with the oil. I guess I need to replace Prop Shaft Seals. Does anyone know how much on average it costs.?
I found a boat repair shop that charges $75 an hour but want to know...
I have a Force 40 HP and recently will not fully start unless I spray a little gas in the carburetor.
I've had this boat for two years, new to boating and it used to start although it took few cranking's before turning over..
Can anyone please give me some tips what I can do so I do not have to...