Logo
FULL SITE MENU

Recent content by Glasply21

  1. G

    280 oil slinger washer

    I have a 1979 280 outdrive where I have taken the upper gear box (transmission) apart and ordered parts I will be replacing. I took pictures as I went along but may have missed one important photo. When replacing bearing and races for the double bearing box, does the oil slinger washer...
  2. G

    280 pre-stressing bearings

    Hello to all. I have a 1979 VP 280 in a 21 ft Glasply which is powered by 350 Chevy Vortec which I built. The boat originally had a 305 Chevy. I have owned the boat for 25 years. The PDS bearings have been done twice by a Tech and about every 3 years I pull the transmission off and have a Tech...
  3. G

    Obtaining correct Quench

    I have a desire to build a 350 chevy and bore it .030" over. (355 ci) This will be put in 21' Glasply cuddy cabin hard top. Appr wt #5000 My piston choice will be a D-dish piston that tries to match the combustion chamber shape. My block is a Gen I (suppose to be a 1999) roller cam and...
  4. G

    280 hinge pin removal

    I am in the process of "trying" to remove the keeper bolts and hinge pins in my 1979 280 OD. I have gotten lucky so far and managed to get one side keeper bolt out by using some heat. No such luck on the port side. At this moment I have the upper and lower units removed so I am only dealing with...
See more
Back
Top