Hey guys, has anyone dealt with this before? I have a squeal coming from somewhere and can't seem to identify it. You can hear it in this video, it's at a higher pitch. Thanks in advance.
2008 60hp Merc 2-stroke
https://youtu.be/zHmU_417pWU
Hey guys I have a 5 m aluminum boat. It's an old Clark abalone I'm in Australia. The bow eye plate that was welded to the front is starting to wear through. There's not much left for the stap hook to hold onto.
I'm thinking about cutting off the worn bow eye plate and installing a stainless...
Greetings my very helpful friends. Does this water pump base assembly need to be replaced when I do my water pump service? Or will I be OK with just the impeller, impeller base plate and gaskets. Keeping in mind that the housing is in good condition. It's a 2008 60hp two-stroke.
Rather not...
Hey guys, I've got a 2008 60hp sn# 1b729008. I notice from the parts lists there a are two water pump repair kit options. One for 1.64 and 2.33 gear ratio.
My motor is not a big foot, can anyone tell me which one I should buy?
Thanks here's the link...
Hi Guys, just bought a 2008 60hp Mercury 2 stroke SN# 1b729008.
Can anyone give my some advice on the water pump and thermostat change? I've done bot on my 90hp 90's ELPTO but nothing on this one yet. For the thermostat mainly just bolt order and tension.
Thanks in advance!
88 Mariner 90hp 3cyl
Hey guys, my tilt in was being limited by a bolt in the second to last hole closest to the transom. In certain application I can't tilt in enough and its pissing me off. Can I remove this bolt completely and have no tilt in limitation at all or must I run a stopper bolt...
Hey guys,
I've over torqued my cylinder block cover / water jacket bolts on my 1988 90hp. In doing so I cracked the thermostat hosing. They are currently in there at about 30 ft pnds, ive come to find out that they should be at 18 ft pnds.
Will it be ok to just leave them or should I take...
90hp Mariner 3-cyl 1988
Hi guys, I want to do my carbs because the engine dies / shuts off when I trim up coming back in to the docks. This is a pain as you can imagine for trailering purposes. I don't think I'm over trimming here either. I'm not going up by much and definitely not exiting the...
Hi Guys,
What is this hole for on the drive shaft housing? I also noticed that there was a silver nipple/nub in front of the shift shaft on the lower unit that it seems to line up/mate to. Water seems to gush from this hole when the motor is running on the hose. Thanks
Hi guys,
1988 90hp 3-cyl Mairiner
Got something I just can't figure out! Been doing a lot of searching! I installed a new water pump the other day and when I put her back together I tested out the gears with the engine off. Forward was OK, neutral seemed to work and also reverse. But when...
Hey guys I ordered this oil injection bushing for my 90 hp Merc three cylinder. Was this the bushing that was updated? Is it supposed have a mark on the flange, this one doesn't. Perhaps I got an old part? Thanks
Part number is 23-17597...
Hi guys,
Thanks for the help with motor so far. I'm trying to piece my machine back together and am wondering about the hoses coming off the reservoir. One hose is just hanging form the nipple on the top of the resevior and has been plugged at its end with a screw. Where should this be...