hi. i bought a used aq125, put it in, put antifreeze in and it started pouring out at rear of intake manifold. took off manifold and it has the wrong gasket on it. it doesn't cover the hole where the antifreeze is coming out. my question is, does that hole need a plug in it or is the new gasket...
hi, i am putting in a aq125 to replace a bad one. i noticed that just above the intake manifold are 4 expansion plug holes. on both motors the 3rd from the front, are holes in the center. is this normal. THANKS, BILL
My engine is almost out but my biggest worry is getting it lined up when putting it back in. I can't find any info on how to get it alighned. any help would help. Triangulation is what I hear but no way to do it. And do I really need new big rubber sealing rings. Thanks, BILL
hi, just got replacement flywheel housing with shaft and bearings installed. it has a lube port but not a zerk. i'm not sure how to fill thru that. I don't know how much or what type grease is in there. should I remove aft bearing and pump in grease till I see it coming thru. I have some really...
I'll try a different way. does anyone know why in the back of flywheel housing, after i opened it up, there is no seal, no snap ring, just a sealed bearing and i can't get the pds shaft out.
I have aq125 engine with 270 drive. took my boat to repair shop to have lift lock repaired. they took off upper drive and the rear of flywheel housing was beat up from the u joints. They said the pds bearing was bad. they wanted over $ 3000.00 to repair it. I brought boat home. Inside the rear...