Logo
FULL SITE MENU

Recent content by eldstuff

  1. E

    Chrysler 318, RH or LH ?

    I recently purchased 2 used 318's. The starters had been removed but came with the motors. I can find no ID tags or stickers on the engines. The block of one engine has: "4006730-318-4" on the port side and "6-7-78" on the starboard side. Which starter goes on this engine? How do I determine RH...
  2. E

    Fuel filter

    I have 1969 twin 318s and I have no idea when the inline filters were replaced. Each engine has a gas/water separator filter and a fuel filter. In addition they have a metal cased, inline filter near the carbs. This filter is marked FG 28. It is about 4" in length. I have not been able to...
  3. E

    Motor Zincs for 318

    Hi, I've been wo ndering for some time now how many, and locations of the zincs which should be replace in the Chrysler 318s. I've read over my maintenance manual and do not find any info on the zincs. My motors are 1979 vintage with exhausts being raw water cooled. Where can I go for this info?
  4. E

    Raw water Pump not pumping

    I'm having trouble getting my rebuilt sherwood pump to work on my 318. The old one was siezed up after 2 months of setting so I replaced it. Now I get nothing although the belts are taut and pump is turning. I noticed that the pump is above the water level and might have some air on the inlet...
  5. E

    1972 318 fuel pump alternatives

    I have a Chrysler 318 engine about 1972. The fuel pump diaphram is blown. It is a Carter with 0-1053 imprinted on one side. B-3 is on the attaching flange. On this fuel pump when the diaphram is ruptured excess gas goes into the bilge. Not good! I'm looking for a replacement which is still...
See more
Back
Top