Logo
FULL SITE MENU

Recent content by ejbreeze

  1. E

    3 Wire Trim Sender

    I am installing a CPO gimball for a bravo one. The port side trim sender has 3 wires coming out that lead into a plug. The wires are labeled A, B, and C. Does anybody have a wiring schematic for this style. All I have seen are the senders with two wires. Thanks.
  2. E

    Bell Housing and Mounts

    Is there an easy way to remove Is there an easy way to remove old engine mounts from a bell housing other than having them pressed out at a machine shop?
  3. E

    Preluber

    I am kicking around the idea o I am kicking around the idea of purchasing a pre-luber. I would like to get everyone's opinion on if they are worth the money. I am partial to the ones that have a pump motor vs. the ones that hold pressure in a tank. Thanks
  4. E

    Installing a new transom housing and drive

    "It has been seven months sinc "It has been seven months since I stripped down my 1984 26' Sleekcraft Ambassador. During this time the boat has been undergoing extensive fiberglass and gel work. Here is how the boat looked before the tear down. The boat was then sanded down and...
  5. E

    How to change the reservoir on a saginaw pump

    How does the reservoir only on How does the reservoir only on a Saginaw P series pump come off leaving the pump only. I am trying to add a March billet reservoir on my existing pump. Thanks
  6. E

    Thinking about repowering this way

    "http://www.youtube.co "[url=""]http://www.youtube.com/watch?v=K9GOJt5mRIg"
  7. E

    Removing Pulley From Sea Pump

    "What is the best way to remov "What is the best way to remove the pulley from a sea water pump/fuel pump combo as shown here: http://www.marinepowerservice.com/BoatingStore/browse_detail3.cfm?productID=4146 5 Thanks"
  8. E

    Sterndrive swap

    "I am taking advantage of the "I am taking advantage of the slower economy and great prices and decided to update my 1984 26' Sleekcraft Ambassador. The boat's at the fiberglass shop now and I am going to replace the alpha drive with a bravo drive. Holding the Bravo drive template up to my...
  9. E

    Wiring at alternator

    "I am installing a new wire ha "I am installing a new wire harness on my 1988 350 magnum. The diagram shows going to the alternator a red with purple stripe, orange, purple and a black wire. My alternator does not have enough terminal as the diagram shows. I have a ground and a positive...
  10. E

    150 alpha to 184

    "Hi All Recently bought a 1 "Hi All Recently bought a 1984 26ft Sleekcraft with a Mercruiser 350 Magnum and a Alpha drive with a 1.50 ratio. The boat at WOT, around 4800-5000 rpm, will due about 48 mph. I know I can increase the prop to achieve a higher mph and lower my rpm a tad but I...
See more
Back
Top