Logo
FULL SITE MENU

Recent content by drphil

  1. D

    Can I skimp a little on electronic distributors, I am updating carbs from Quadrojets to edelbrocks

    I have twin 350 crusaders and am updating carbs to Edelbrock's and was wondering if I could just use an electronic kit to update the distributors in my 84 uniflite. Hours on both motors is 426, so dont think the distributor should have too much play, but cost between new distributors and kit is...
  2. D

    squirrel cage for blower

    Mud dobbers left there mud in the blower and it destroyed my squirrel cage on the blower. Does anyone know where I could get a new one. Too cheap to throw away the unit when all I need is the squirrel cage. Don't know where to place this but it is on my boat with crusaders. Thanks Phil
  3. D

    84 crusaders 350's, with 320 hours

    Talked with you guys earlier about 84 unflite one owner very low hours 320. Have purchased and found a little normal problem, port motor running a little warmer when pushed hard for a while then when backed off it cools down to 160-170, got up to 180ish starboard stayed rock solid at 160. Bought...
  4. D

    Sbc crusaders 84 model low hours

    "Less than 390 hours on 25 yea "Less than 390 hours on 25 year old boat. Compression great, boat great shape, one owner boat anal about maintenance. This low of hours what will be problems, were they run enough to even burn off condensation in the oil? Gas is old, carbs look like they need...
  5. D

    Carbs new then changed fuel filter and problems

    "Hey can I have too fine of fi "Hey can I have too fine of filter after fuel pump, and can it cause flow problems to carb. Things were ok then changed filters as instructed by warranty and now problems. Plese som help, just rebuilt starboard motor and it really ran great, now trouble."
  6. D

    Tuneup carb plugs and new big block wires

    "had fresh water impeller key "had fresh water impeller key slip and motor got hot. Blown head gasket, upon removal found riser leaking water into back cylinder, rust in maninfold. Had heads rebuilt, resurfaced new riser and carbs vatted and rebuilt. Have put 1 inch riser on carbs and new...
See more
Back
Top