Logo
FULL SITE MENU

Recent content by DLC8113

  1. D

    25HP Oil and Temp Warning

    I actually picked one up, but am not sure the wiring in the tiller is there for it.
  2. D

    BF 25 Cold Start flooding.

    It's been a while since I worked on this. I've discovered a potential issue, but can't find what I need to make sure I get the correct parts. It looks like I have the old bystarter that begins with DR, and the float bowl has a 75 on it. The bystarter passage is clear, but I feel like there might...
  3. D

    25HP Oil and Temp Warning

    According to my serial number, I have a 2006 motor. (BATJ-1200600) The parts schematic shows the oil and overheat light panel on the long handle tiller. The one on my motor is degraded by the sun, and the lights were not visible. I ordered a new display, and was about to put it on, when I see...
  4. D

    BF 25 Cold Start flooding.

    I tried 2 cold starts over a couple of days. Right now, I'm not going to try changing anything. Both times, I cracked the throttle just a hair after a couple of seconds of cranking, and it fired right up.
  5. D

    BF 25 Cold Start flooding.

    Yep. All things already blow free and clean Thanks
  6. D

    BF 25 Cold Start flooding.

    Thanks for the input. I've not seen it before either. The bystarter works and appears to fully shutoff as it warms up. Bowl, etc all look unmolested. It might be a day or 2 before I get back on it. I hate to pull the carbs to adjust float levels. That will be a last resort. I will probably...
  7. D

    BF 25 Cold Start flooding.

    I recently purchased a 2006 BF25. (BATJ 1200600). I had to clean water out of rhe carbs and chose to replace the nasty slow speed jet tube and float needles that were binding in the seats from crusty stuff. Floats are at 14mm per spec. I understand how the bystarter operates, but on cold...
See more
Back
Top