Logo
FULL SITE MENU

Recent content by D4V33

  1. D

    Outboard bogs down and dies once heated up.

    Hi, I think it was down to a fault fuel pump. This comes as part of the carb setup on this engine, so I replaced the lot. It looks like the little metal reed type bales in the pump where not sealing properly. I have not yet had a chance to put it on the water, so not 100% to whether this has...
  2. D

    Outboard bogs down and dies once heated up.

    One thing I did notice, when I was cleaning the carburetor a couple of days ago was that it doesn’t have this little rubber grommet shown in the exploded part diagram. I cut one out of some sheet rubber I have and place it in the carb and the outboard wouldn’t start. Once I removed it the...
  3. D

    Outboard bogs down and dies once heated up.

    Tohatsu M18E2 18hp 2stroke This is a follow on from my last post. I thought i had a carb mixture issue as engine was running poor last week. I set the carbs and had it running nice for well over half an hour in a bucket of water. Took the boat to the harbour today and started it up. Being that...
  4. D

    Tohatsu M18e2

    Much appreciated, thank you
  5. D

    Tohatsu M18e2

    Hi all, I’ve got an Tohatsu 18hp 2stroke outboard that when tested in the water would die at high revs. I’ve fitted new plugs, new fuel and stripped and given the carbs a good clean. I found the mixture screw was excessively turned out (by previous owner) so have tried to reset it while running...
  6. D

    Dory 13 auxiliary bracket help

    Hi all, I have a dell quay dory 13 that I would like to fit an auxiliary outboard to for piece of mind. I tend to only ever take the boat out when someone else takes theirs out, but would like to go out on my own without the worry of getting stuck if I ever have engine troubles. doos anyone...
  7. D

    Mariner 675 60hp controller wires

    Hi all, I’ve just transferred my old outboard onto my Dory and need a new controller and cables as the one I have a way too long. I can’t seem to find a controller that has 7 terminal harness that’s compatible. Either I find one that’s a straight fit or i find a different controller and will...
  8. D

    Mariner 60hp idle problem

    Hi all, I have an old mariner 60hp 2 stroke outboard. I believe it was originally Yamaha. Have also seen 55hp version. Was planning on taking the boat out soon now the weathers getting better, but seem to be having idleing problems. The engine keeps coughing and sometimes bogs down and...
See more
Back
Top