Logo
FULL SITE MENU

Recent content by crashband

  1. C

    Chrysler 318/360 Marine Inboard Starter

    I picked up a IMI Hi-torque starter not too long ago to replace the old style bendix drive. The new one has an extra post to the solenoid whereas the old one just had the post to to ignition. Here is a photo of what I'm referring to:
  2. C

    Chrysler 318/360 Marine Inboard Starter

    Not to bring an old thread back from the dead, but this is very much relevant. My bendix starter finally decided to give up the ghost. Currently looking around for alternatives and see the new IMI units on ebay listed for Marine. Since my engine is a standard rotation, the flywheel spins CCW...
  3. C

    Bench Starting 318 Electric Ignition

    Hi all, I have a 225HP Chrysler 318 with electric ignition that I would like to start on a bench? Does anyone know how to wire it up for a simple bench start?
  4. C

    318 Fuel line

    Hello all, Does anyone know if there is a aftermarket fuel line that runs from the fuel pump to the carb that isn't copper? I need to find a replacement and can't find anyone or anywhere that sells the copper setup. I believe the fuel pump outlet is a 5/16 fitting and the 1409 carb inlet is a...
  5. C

    Correct Transmission output?

    Hey guys, Still having ALOT of trouble understanding rotation on engines so was hoping someone could point me in the "right direction". Had a reverse rotation 318 (single screw) that had a 1:1 BW and a Walter V-Drive (no idler gear). Being stupid and impulsive, I accidentally purchased a...
  6. C

    Chrysler 318 Inboard ersions

    Good evening Gents, I currently have a raw water cooled electronic ignition LM318 connected to a v-drive in a 79 Silverton 26' Flybridge. Due to neglect from the PO, the exhaust manifolds, risers and part of the cylinder heads are rotted out from seawater deposits. I am currently looking at a...
See more
Back
Top