I am new to this section of the forum but not the forum. I just purchased a 1983 Mercury 3.5hp. Serial# 6278778 and need to varify the fuel/oil mixture ratio. Is it 50:1?
Thanks
Bob Koss
"Based on a recommendation in
"Based on a recommendation in an earlier post I would like to know if there is an advantage to change to an electric choke? I have a 1989 Slickcraft with a MCM 5.7L Mercruiser and a 4MC Rochester carbureture Mercury No. 1347-9662. This is a project boat and I have...
"I have read all of the resent
"I have read all of the resent discussions about Trim/Tilt problems searching for a solution for the problems I am having with my boat. The basic problem is the same as described in other threads. After re-assembly of the Bell Housing and outdrive, the Trim/Tilt...
"History: I purchased a 1989 S
"History: I purchased a 1989 Slickcraft as a project boat. It had been sitting for almost 3 years with the engine out and dissembled due to a dropped valve. All of the engine part where suppose to be in the boxes that came with the boat. (No Way). Rather then deal...
"Can anyone tell me about the
"Can anyone tell me about the Mercathode System? What does it do? How does it do it? And, is it needed on a trailered boat that is normally in the water for less then a day at a time??
Thanks. Your help is appreciated.
Bob"
"I need to replace the steerin
"I need to replace the steering cable on my project boat. The local Marine Trading Post recommends replacing my Rack & Pinion system with a rotary system.
Which is the better system??
My boat is a 1989 24' Slickcraft with power steering, and soon to be running...
"I have just installed a 5.7L
"I have just installed a 5.7L long block in my 1989 Slickcraft. The engine builder has a Pre-Lubrication Procedure that requires cranking the engine without the sparkplugs for 2 minutes after the oil preasure gage indicates oil pressure. I removed the oil sending...
"Can anyone tell me the correc
"Can anyone tell me the correct way to wire the starter for a 1989 5.7 L 350 V-8. I tried using the wire diagram for the Mercrusier Shop Manual but it not clear. I also have a Selco Manual and that the source of my confusion. Seloc has 2 diagrams for my engine...
I need advise or recommendatio
I need advise or recommendations for the installation of a 5.7L in a 1989 Slickcraft. I purchased the boat with the engine out and in pieces. I am installing a rebuilt log block. I would like to know if the engine should be completely assembled before installing...
"Can anyone tell me if Mercrui
"Can anyone tell me if Mercruiser starters are different then an auto starter?? Or, can an auto starter be used on a marine engine??
Thanks
Bob K"
"I am new to the group. Just p
"I am new to the group. Just purchased a 1989 Slickcraft with a 5.7 Alpha 1 stearn drive. It was purchased as a project boat. Has been sitting with the engine out for 2+ years. (Dropped Valve). I will be installing a long block from S&S. I started cleaning the...