Logo
FULL SITE MENU

Recent content by Apexmaster34

  1. A

    MAN D2842 Intercooler instsall on 56ft Bayliner

    hello im working on a 56 bayliner. it has the D2842 2 valve MAN. I need to install the inter coolers on top of the engine. the engine room does not have a crane. any suggestions other than man handling 250lbs up 5ft?
  2. A

    15hp carb tuning

    hello i have finally completed assembly of my 87 15hp electric start motor. i am having a lot of problems with tuning the carb. I have completed rebuild the carb, and installed new gaskets. I have the 87 late model carb with the black plastic top cover. i even installed a new throttle roller...
  3. A

    87 15hp outboard carb tune

    Hey guys need some advice and help on tunning the carb. After assembly of carb and setting all adjustment to stock specs from manual, I can start engine in Neutral idles fines and revs. As soon as I put in gear and give throttle the engine bogs down? What I'm I doing wrong?
  4. A

    87 15hp safety switch ?

    Hey guys my safety switch down by the gear lever pretty much has fallen apart in pieces from age. I cannot find a replacement switch anywhere, in online parts catalog it's not even listed. Any ideas?
  5. A

    15hp evinrude coolant passages

    Hi guys I have been working on this 15hp 87 motor for almost a year. I got the motor for free. I have done everything that was broken on it. Last issue is my coolant flow. When engine running I don't get any water flow from the small port on bottom of the cover. See videos. I flow air to see...
  6. A

    15hp Evinrude Starts & Dies?

    I have a 89 15hp w electric start out hard. i have rebuild carb with a kit all new comp. New plugs , wire, New fuel filter. Engine starts ,runs for about 5sec then dies. I have checked everything over and over . When I hot starter I see fuel flowing to carb while cranking, so there is fuel Also...
  7. A

    15 HP Evinrude No Water Flow

    the engine is not circulating water. i have a water pump OEM kit installed, with the pin in correct spot, I have removed my thermostat and test in hot water, cleared all coolant passages with shop air, and i am still not getting any flow through the motor. I get a little drip, drip but not...
  8. A

    89 15 hp Evinrude Idle issue

    hello, I have a 89 15 hp, with very low run time only about 20 hours. but it has sat for over 20 years, last week i finished doing a complete tare down, on carb, reed valve, spark plugs, new head gasket, etc. it has electric start. engine starts as it should but will not idle by it self. i have...
See more
Back
Top