Logo
FULL SITE MENU

Recent content by aday_in_nh

  1. A

    Edelbrock 1409 help tuning

    "I successfully installed my E "I successfully installed my Edelbrock 1409 onto my M360. As others have commented, very easy and straightforward install. Low idle mixture screws are set but I can't seem to get a smooth transition to higher rpm's. In other words, when I accelerate from 8-900...
  2. A

    M360 mufflers in a resorter

    "Thought I would poll the grou "Thought I would poll the group and see if anyone has successfully mounted "Verna-Ski" mufflers in an M360 powered Resorter. Manufacturer of the muffler says for "above waterline applications", but my questions is, my Resorter exhaust is at or slightly below the...
  3. A

    LM360 what plugs to use

    1983 LM360 - Just want to be s 1983 LM360 - Just want to be sure I'm running the right spark plugs. Anyone know what plug I should be using? Thanks.
  4. A

    LM360 rough idle with gas smell from exhaust

    "Thought I would pose this to "Thought I would pose this to the group. Used the boat today for the first time since a busy ski weekend - about two tanks of gas. The first part of todays ride was good and ran well, but when decelerating and idling in to the dock it felt like it was missing at...
  5. A

    LM340 major cooling system leak

    "Engine is running strong - ha "Engine is running strong - had it out running today (18' Resorter). As I was returning to the dock I caught a wiff of an overheating smell - temp gauge was at 140. Opened the engine box and found water being slung up by the flywheel over everything. Shut the...
  6. A

    Torque settings on LM340 manifold

    "Getting ready to reinstall ex "Getting ready to reinstall exhaust manifolds on an LM340. Can anyone tell me what the torque settings should be on the mounting studs? Also, torque settings on the end caps and exhaust risers would be helpfull too. Thanks and Merry Christmas."
See more
Back
Top