Logo
FULL SITE MENU

Recent content by 94evin150

  1. 9

    94 evinrude 150

    Think i found the problem the plastic part that seperates the oil and fuel line going into the cowel leeks a steady stream when priming the bulb so my question is can i delete that part and run strait Pieces.
  2. 9

    94 evinrude 150

    Ok thank you
  3. 9

    94 evinrude 150

    It pisses water like a horse and havent tryed external tank yet
  4. 9

    94 evinrude 150

    Ok ill check those and i did have a leak at gas filter at one time but the new filters dont come with orings i assume standard oring will work
  5. 9

    94 evinrude 150

    All cyl read 97 to 100 psi and i checked spark on all plugs didint test the jump gap but had strong spark. vst? Oms? Sorry not shure what those are and im going to need a cuple cans of carb clean to dry the intake side of motor due to being saturated with gas and oil over the years to determine...
  6. 9

    94 evinrude 150

    When in the water on the hole shot for the first 10sec it has full power but then dies back off like its starving for fuel and running top end you can feel the motor surge like it gets full power for a sec
  7. 9

    94 evinrude 150

    Ive put new plugs in and ran it for about 20 min out of water and rechecked plugs and they all looked like thay where burning the same i checked the timing at idol and that was normal . It runs alot better out of the water for some reason most problems are under a load
  8. 9

    94 evinrude 150

    I did just rebuild all 6 carbs but not bowls and i do remeber a carb or two being wet and the fuel line after the bulb is dry rotted and wet in spots
  9. 9

    94 evinrude 150

    I have a problem with rough idol and lack of power. I can hammer down and it takes off good but lose power shortly after hole shot. Once on plain and full throttle you can hear and feel the motor give more then back off and fyi the primmer buld never gets hard and stays hard and line is whether...
See more
Back
Top