I’ve got a 350 MAG MPI and the serial number is 0L316222
The ecm is MEFI2
It has had a code for “low oil pressure tell tale indicator set”
the scan tool also reads “fault switches problem”
it has an oil pressure switch by the distributor and a bell style oil pressure sender on port side of...
I’ve got a 1994 Natique with a PCM 5.8 Protech injected engine. It’s been running rough and stumbling intermittently. Fuel pressure at the Schrader port is showing 17 psi on the rail. That seems low to me but I can’t find the spec anywhere. Can some one please tell me what the pressure should be
I'm looking at a boat that is equipped with an OMC King Cobra drive. I know a lot of the parts are NLA and I'm also aware that these drives are pretty tough. Is there anything I should look for when checking this boat out? Trouble area? Tell tale signs of wear and tear/abuse? I'm probably going...
This page is a great resource for boaters with repair and trouble shooting questions. This page also lacks on the personal level. It needs a non repair section for ALL members to be able correspond with each other and gain trust and friendships. Lots of other boating forums have sections not...
Long story short. My dad bought a '79 glastron 17ft boat for my sister for her graduating with a masters. Boat is in mint condition. Has sat inside for last 25 years. Runs like a champ. For some reason somebody took the original fuel tank out and was running remote tanks. We decided to buy a new...
I've got the merc silent choice setup on my boat and it's leaking water around the bushing and seal where the flapper rod comes thru the side of the pipe, I've got new seals and bushings but I'm not sure how to go about replacing them. Can I do it ithe boat or do I have to take the diverter off...
Working on a 1993 50 hp on a pontoon boat. The boat was sitting for a few years and while sitting somebody tried to steal motor and cut all wires and cables. Ordered new remote and wiring harness and cables and installed them. Boat started ok but ended up needing carbs cleaned. Done. Now we are...
My aunt has a boat with an alpha 1 gen 1. She said they noticed oil leaking from around the prop and doesn't know what to do. My guess is prop shaft seal. Anybody else have an idea as to what it could be? Are any specialty tools needed to change that seal if that ends up being the case?
Working on a 1988 5.7 King Cobra, replaced the lower (red) shift cable because it was stuck in forward gear would not go to reverse or neutral. does a king cobra have cone clutches and if so will it get stuck in gear if shifted while the boat is not running?? we have it shifting to reverse...