Logo
FULL SITE MENU
T

Texasmark

Advanced Contributor From TX.
Joined
Last seen
Messages
866
Reaction score
0

Latest activity Postings About

    • T
      Texasmark replied to the thread 2000 40hp ELPTO cant shut off.
      Agree. Either water or metal shavings have shorted out contacts internally to the switch.
    • T
      Texasmark replied to the thread One long beep.
      Some engines beep at the turn of the key to tell the operator that the warning system is functioning properly. I don't know the duration.
    • T
      Texasmark replied to the thread Connector Leak.
      That's not your speedometer pickup circuit.
    • T
      Texasmark replied to the thread Connector Leak.
      I pulled up your reference. Is the connector at the front of the midsection just above where the lower unit attaches or in that area at...
    • T
      Texasmark replied to the thread Connector Leak.
      Well I pulled up your reference material and see a plastic rt angle connector. Not knowing anything else I would expect that the rubber...
    • T
      Texasmark replied to the thread 2017 Pro XS 115 Trim/Tilt.
      Not knowing your situation I would say that the contacts within the tilt-trim relays are pitted due to old age and are sticking when...
    • T
      Texasmark replied to the thread Low compression.
      My owner's/service manuals for my 75-125 HP engines states that anything below 120 PSI is curtains. I would think that since we are...
    • T
      Texasmark replied to the thread How to measure a Lower Unit Drive Shaft?.
      I don't know to start! With that said, I would think that since shaft lengths vary by 5"....15", 20", 25", a 1"variation in the gear...
    • T
      Texasmark replied to the thread SPARKPLUG Gap on 9.9 Merc What should it be? Year 2000.
      Glad to help!
    • T
      Texasmark replied to the thread SPARKPLUG Gap on 9.9 Merc What should it be? Year 2000.
      Most plugs are pre-gapped these days by part number. Since no one replied, I don't know but I would expect that if you replaced the...
    • T
      Texasmark replied to the thread 2003 ignition harness questions.
      On some harnesses, that wire and an other are dressed on the outside. If like on the larger engines, find the OH sender...on larger...
    • T
      Texasmark replied to the thread 1995, 115 HP questions.
      I tried adding this to the above post and the 5 minute time limit (why so short....I had to go pee) so here are a couple of additional...
    • T
      Texasmark replied to the thread 1995, 115 HP questions.
      The idle RPM is set by the spark advance for 675 +/- 50 in the water in F gear, boat moving. Carbs start off at 1 1/2 open from a...
    • T
      Texasmark replied to the thread Lower Unit Ratio Question.
      I was going to add to the above and the time expired on a change. So here is the whole shebang. Can't be a bad thing...........tons of...
    • T
      Texasmark replied to the thread Lower Unit Ratio Question.
      Can't be a bad thing...........tons of variables here but basically you have a gear train and the engine RPMs, aka drive shaft RPMs vs...
    Show older items
  • Loading…
  • Loading…
Back
Top