Logo
K
Reaction score
0

Latest activity Postings About

    • K
      kevinj replied to the thread Plugs and gas.
      Always Champions plugs in my Evinrude engines and Faztbullet gave you the right plug # for your engine. I also exclusively run...
    • K
      Oh boy, now you're going down a rabbit hole! You can sometimes find a real gem and you can also find a pile of scrap. There are plenty...
    • K
      kevinj replied to the thread 1996 Evinrude keeps shutting off.
      You have a fuel delivery problem. This could be an air leak in the lines, a sticking anti-siphon valve in the tank, a bad diaphragm in...
    • K
      The CDI Electronics installation and troubleshooting guide will help you know the exact readings you should have on each lead.
    • K
      Is that 1500RPM out of the water on muffs or in the water? Without any back pressure, 1500RPM on a set of hose muffs isn't too far out...
    • K
      I believe faztbullet's question is which BRAND of aftermarket power pack did you buy? If it's Sierra or CDI electronics they tend to...
    • K
      kevinj replied to the thread Lower end oil??.
      Yep, BRP HPF Pro is what I use in my lower unit. A lot of people use Quicksilver because that's what is readily available at Walmart...
    • K
      kevinj replied to the thread Shift rod replacement.
      #1, make sure your shift shaft seals on the LU are in good shape, if not they will leak water in the LU. Now is the time to perform...
    • K
      kevinj replied to the thread 225 Johnson won’t go into gear.
      Agreed with Racer, we need a little more back story. As for troubleshooting, remove the shift cable from the shift linkage on the...
    • K
      Tims Outboard in MN has a great selection of good used parts for these older outboards. I had a 25HP short shaft I wanted to convert to...
    • K
      Fuel starvation at WOT will not present itself as a misfire. If you are fuel starved you'll either bog down or not be able to reach max...
    • K
      kevinj replied to the thread 9.9 won't low idle.
      Agreed, post compression #'s. If you had a hot alarm and you've set everything properly on the carb and you still have running issues...
    • K
      kevinj replied to the thread using a VRO as a fuel pump.
      Jeremy, If properly capped the fuel side of the VRO pump will work fine. However, keep in mind you are using a 33 year pulse driven...
    • K
      To echo Tim, remove the knob from your low speed needle valve and check how it is set. Put a flat blade screw driver on it and count...
    • K
      kevinj replied to the thread 9.9 won't low idle.
      Agreed. Your title says 9.9 but then you talk about a 99 Johnson. Please post your model number so we know exactly which outboard is...
  • Loading…
  • Loading…
Back
Top