Answered my own question by measuring the diameter of the shaft above and below the bearing. Below the bearing is .005 less in diameter than above, so
mills Yesterday, 10:06 PMWell there's that but finding TDC is not so complex that you will find very much contradictory information.
You pull out number one plug, stick
Well heck yes. You are going to be charging the batteries anyway.
fdrgator Yesterday, 07:05 PMThanks guys. It’s just a 14’ Jon boat we use for ducks & fishing some of the rivers & smaller lakes around here. Much easier than
Edchris177 Yesterday, 06:15 PM
471 hydraulic govner
I have a Detroit 471 that was used as a genset it has a hydraulic govner on it that was set to 1200rpm .my question is can I set up the hydraulic govner
Morg7 Today, 12:55 AM