as far as I can tell I only seen the purple wire attached to the tach. I will have to go back and check all other components to see where else it may
I didn't check that figured cause it was running when it died was more fuel related. its 2007 BAGJ 1500279 Not sure of video will work.
Just a note figured this one out the key switch (very old) lost the 12 V "run" signal while it was cranking due to worn out contacts. New switch
Hi all, I recently purchased a Yamaha HPDI 200 for my 19’ center console. The motor has 100+ compression and is within 10% range in all cylinders.
To make sure I’m doing this correctly I will be prying the black plastic linkage pivot off the throttle lever. When I get the throttle cable disconnected
Browse Sections
Recent Forum Posts
Re: Ignition fuse blowing
as far as I can tell I only seen the purple wire attached to the tach. I will have to go back and check all other components to see where else it may
Bruinut Today, 10:09 AM