• Jaybird88

    There is no available content written by Jaybird88
  • Recent Forum Posts

    joereeves

    Re: 1984 Evinrude 15 Hp needs prime?

    The throttle butterfly should just start to open when the scribe mark on the cam is dead center with the throttle roller. Is that where you sat it?

    joereeves Today, 01:06 PM Go to last post
    tekati

    1979 OMC 260/800 - No shift engine off.

    I have a 1980 Sea-Ray 225 with a OMC 260 model: 990262S which is a 1979 260 with the 800 Sterndrive left the model off since it appears to only be used

    tekati Today, 01:03 PM Go to last post
    LumleyRick

    Re: Coils

    What causes the coils to get cracked and white stuff on them. Does it mean the engine was used a lot or can they get like that just from sitting for years

    LumleyRick Today, 12:43 PM Go to last post
    FCcarp

    Re: 1984 Evinrude 15 Hp needs prime?

    My problem went away after I adjusted the small screw just below the cam wheel that gets pushed forwards when the throttle is placed in the full position

    FCcarp Today, 11:37 AM Go to last post
    bondo

    Re: Is this torsion arm trashed

    Ayuh,... The most common failure point with torsional axles are the rubber blocks in the axle tube,.....

    The steel pieces can be cleaned

    bondo Today, 11:25 AM Go to last post