• Recent Forum Posts


    Re: soft spot

    I have seen the videos on that type of repair it is just an expensive band aid. You need to cut out all the dryrot and replace with new marine grade plywood

    kimcrwbr1 Today, 08:50 AM Go to last post

    Re: m90a Help

    Thanks again Paul,

    Leads were just old ones I used just to see if the motor would do anything! I will be making up new leads but wanted

    whaler_warner Today, 08:25 AM Go to last post

    Re: m90a Help

    Any block or starter ground is fine for the battery ground cable. It came from the Factory attached to the block near the starter solenoid.
    If the

    pvanv Today, 08:09 AM Go to last post

    Re: Best Carrier Bearing Tool For Old Evinrude?

    Thats 100% the truth!!!!

    faztbullet Today, 07:45 AM Go to last post

    Re: soft spot

    Ayuh,.... So is it a cast fiberglass liner, or plywood deck,..??

    bondo Today, 07:23 AM Go to last post