Logo
Page 1 of 46 12311 ... LastLast
Threads 1 to 50 of 2261

Forum Home: OMC Sterndrive and Inboard Forum

Sub-Forums Threads / Posts  Last Post

  1. Forum Actions:

    Forum Statistics:

    • Threads: 2,250
    • Posts: 11,188
  1. low speed misfire

    Started by 01subaruRS, 05-25-2012 11:14 PM
    • Replies: 3
    • Views: 734
    06-03-2012, 12:56 PM Go to last post
  2. King (Big Daddy) Cobra shift cable Replacement

    Started by 1011hans, 07-24-2017 05:40 PM
    • Replies: 0
    • Views: 381
    07-24-2017, 05:40 PM Go to last post
  3. 1977 190 OMC stumbling issue

    Started by 12splash, 07-28-2011 12:09 AM
    • Replies: 11
    • Views: 1,491
    09-02-2011, 06:17 PM Go to last post
  4. upgrade to electronic ignition 1989 2.3 L

    Started by 134rocks, 08-02-2010 05:36 PM
    • Replies: 17
    • Views: 7,282
    08-10-2010, 11:19 AM Go to last post
  5. 1976hydroswift transom seal replacement

    Started by 1976Hydroswift, 06-02-2011 06:19 PM
    • Replies: 2
    • Views: 526
    06-02-2011, 09:28 PM Go to last post
  6. 1987 Bayliner Trophy with OMC 305 Help

    Started by 1987Bayliner, 06-07-2017 09:47 PM
    • Replies: 0
    • Views: 195
    06-07-2017, 09:47 PM Go to last post
  7. OMC 305 Starter Problems.

    Started by 1987Bayliner, 06-07-2017 10:16 PM
    • Replies: 15
    • Views: 586
    06-21-2017, 11:58 AM Go to last post
  8. Ford 2.3lt OMC is overheating at idle.

    Started by 1987larsoncitation, 06-07-2011 12:29 AM
    • Replies: 9
    • Views: 1,076
    06-09-2011, 07:00 AM Go to last post
  9. !989 Four Winns no start

    Started by 1989 Four Winns, 06-24-2012 05:48 PM
    • Replies: 1
    • Views: 301
    06-25-2012, 11:24 AM Go to last post
    • Replies: 5
    • Views: 4,932
    06-20-2010, 05:20 PM Go to last post
  10. 1980 omc 80 hp 800 NO REVERSE

    Started by 19beachcraft, 02-09-2011 11:24 PM
    • Replies: 10
    • Views: 1,337
    02-12-2011, 08:45 PM Go to last post
  11. Angry Water incursion omc 4.3l v6

    Started by 1tm315, 05-20-2010 07:20 PM
    • Replies: 3
    • Views: 934
    05-21-2010, 06:49 AM Go to last post
  12. Post trying to take out 76 omc 190 hp 302

    Started by 2010*av44, 06-06-2013 07:50 PM
    • Replies: 2
    • Views: 357
    06-07-2013, 04:30 PM Go to last post
  13. Omc electronic ignitition

    Started by 2459, 02-26-2010 03:11 PM
    • Replies: 4
    • Views: 711
    02-26-2010, 10:01 PM Go to last post
  14. Question OMC Zephyr 15HP 2 stroke cooling question

    Started by 27floater, 04-12-2014 11:07 AM
    • Replies: 4
    • Views: 2,331
    04-14-2014, 03:02 PM Go to last post
  15. '81 omc has no power to prop

    Started by 2ndrate1stmate, 09-20-2011 07:19 PM
    • Replies: 5
    • Views: 609
    09-26-2011, 12:14 AM Go to last post
  16. Avanti 43 omc

    Started by 48ford, 08-09-2009 11:58 AM
    • Replies: 10
    • Views: 420
    05-13-2010, 11:18 PM Go to last post
  17. Missing at 3000 rmps

    Started by 4jhutch, 06-08-2016 10:17 AM
    • Replies: 5
    • Views: 213
    06-09-2016, 04:26 PM Go to last post
    • Replies: 5
    • Views: 1,113
    06-17-2011, 07:27 AM Go to last post
  18. OMC 800 outdrive. Alpha 1, Alpha 2 or What?

    Started by 5054d, 04-19-2010 11:22 AM
    • Replies: 5
    • Views: 3,127
    04-21-2010, 10:35 PM Go to last post
  19. What props for my old Bayliner 800 OMC?

    Started by 5054d, 04-19-2010 11:35 AM
    • Replies: 9
    • Views: 597
    04-21-2010, 10:30 PM Go to last post
  20. OMC Cobra ESA module

    Started by 50kstrafo, 11-28-2011 10:49 AM
    • Replies: 5
    • Views: 5,163
    12-28-2011, 12:03 AM Go to last post
  21. 88 4,3 wiring

    Started by 593 riverview, 09-23-2014 06:06 AM
    • Replies: 1
    • Views: 292
    09-23-2014, 03:10 PM Go to last post
    • Replies: 0
    • Views: 1,092
    10-05-2015, 12:18 AM Go to last post
    • Replies: 5
    • Views: 543
    08-08-2016, 10:38 PM Go to last post
  22. New to the OMC Sterndrive forum

    Started by 60grit, 09-08-2016 12:43 AM
    • Replies: 12
    • Views: 779
    09-15-2016, 02:58 PM Go to last post
    • Replies: 10
    • Views: 484
    06-19-2017, 06:18 PM Go to last post
  23. Intermediate shaft bearings????

    Started by 70cutlasssx, 02-04-2016 11:16 AM
    • Replies: 3
    • Views: 2,467
    05-31-2016, 09:30 PM Go to last post
  24. 84 OMC stringer 800 problems????????

    Started by 70cutlasssx, 06-01-2016 05:51 PM
    • Replies: 0
    • Views: 280
    06-01-2016, 05:51 PM Go to last post
  25. OMC 400/800 stringer??????

    Started by 70cutlasssx, 06-06-2016 10:32 PM
    • Replies: 0
    • Views: 268
    06-06-2016, 10:32 PM Go to last post
  26. steering issue after lower gearcase rebuild?

    Started by 70cutlasssx, 07-04-2017 12:20 PM
    • Replies: 0
    • Views: 361
    07-04-2017, 12:20 PM Go to last post
  27. 76 omc outdrive problem

    Started by 70sfordman, 02-23-2015 01:51 AM
    • Replies: 9
    • Views: 449
    02-28-2015, 10:49 PM Go to last post
    • Replies: 5
    • Views: 888
    08-09-2009, 04:05 AM Go to last post
  28. 1981 inline 6 115 HP won't run low rpms

    Started by 76checkmate, 07-22-2014 10:45 PM
    • Replies: 0
    • Views: 158
    07-22-2014, 10:45 PM Go to last post
  29. omc power tilt problem

    Started by 78glastron, 09-02-2014 07:14 PM
    • Replies: 1
    • Views: 378
    09-22-2014, 08:35 AM Go to last post
  30. OMC 800 Stern Drive Impeller Replacement

    Started by 78Grady, 07-05-2016 09:29 PM
    • Replies: 5
    • Views: 587
    07-07-2016, 09:10 AM Go to last post
  31. 78 3.0 OMC I/O idle rough, gas smell

    Started by 78seasprite, 07-17-2011 10:12 PM
    • Replies: 3
    • Views: 816
    07-20-2011, 07:48 PM Go to last post
  32. Frustrated needing obsolete parts!!!

    Started by 78Thunderbird, 05-27-2012 10:32 PM
    • Replies: 0
    • Views: 434
    05-27-2012, 10:32 PM Go to last post
  33. OMC 800 tilt motor and trim motor

    Started by 79larsonOMC800, 06-09-2015 10:11 AM
    • Replies: 2
    • Views: 279
    06-09-2015, 10:33 PM Go to last post
  34. OMC 800, no spark, please help!

    Started by 79larsonOMC800, 06-05-2015 08:20 PM
    • Replies: 8
    • Views: 298
    06-08-2015, 02:56 PM Go to last post
  35. parts availability 1988 350

    Started by 87concord, 06-11-2010 01:39 AM
    • Replies: 2
    • Views: 414
    06-11-2010, 09:31 AM Go to last post
  36. 1988 350 hp ?

    Started by 87concord, 06-15-2010 10:17 AM
    • Replies: 3
    • Views: 356
    06-15-2010, 05:44 PM Go to last post
  37. Moved: 5.7 King Cobra Trim Issue

    Started by 87concord, 06-22-2010 07:20 PM
    •  
    •  
  38. Moved: King Cobra shift question

    Started by 87concord, 08-05-2010 07:14 PM
    •  
    •  
  39. Need some King Cobra advice (cone clutch drive)

    Started by 87concord, 07-24-2015 12:26 AM
    • Replies: 1
    • Views: 164
    07-26-2015, 11:00 AM Go to last post
  40. OMC Cobra 1988 water in gearcase

    Started by 88 bayliner, 07-04-2010 10:19 PM
    • Replies: 4
    • Views: 1,007
    07-21-2010, 12:07 AM Go to last post
  41. Throttle cable ?

    Started by 88 thundercraft, 09-03-2010 02:33 PM
    • Replies: 16
    • Views: 726
    09-08-2010, 11:47 AM Go to last post
  42. Cool 88 bayliner

    Started by 88bayliner, 05-17-2011 07:10 PM
    • Replies: 5
    • Views: 783
    06-01-2011, 02:14 PM Go to last post

Page 1 of 46 12311 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 10 replies or 100 views
Hot thread with unread posts
More than 10 replies or 100 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •